Hello.
Bios needed for intel nuc NUC8I7HVK
Product cod : BOXNUC8I7HVK2
SN : bthn00400bf
S/A : j71485-602
Dump attached
Bios needed for intel nuc NUC8I7HVK
Product cod : BOXNUC8I7HVK2
SN : bthn00400bf
S/A : j71485-602
Dump attached
-
-
Any help ?
Thank you.
-
Tried something but after almost 60 sec will display an image .
Any solutions ?Comment
-
Comment
-
Don't know how...Comment
-
Tried some youtube instructions , but no luck.Comment
-
Comment
-
I tried the one you maked , the problem i think is not working at all is because this one is the first dump , the one with no display. Still no display with the me_clean.
Can you clean_me the one i tried and has image but has 60 sec delay ?
Is attached .
Thank you very much.Comment
-
Solved.
I managed to take the me_region from your bios and put it in the one with delay. made the new bios file.
Everything works.
Thank you.
Comment
-
Hi, I have an MSI PRO B660M-G DDR4 board with damaged BIOS and i need a bios dump from a real board, along with MAC, UUID and Serial Number info (eg. a BIOS screenshot and pictures from the board stickers).
I need to reconstruct the bios on my board, based on another bios image form a real board - meaning a bios image containing MAC address, UUID and Serial number. A stock BIOS is not suffiecient, as it is impossible to discover where the MAC, UUID and SerialNumber are stored. Tried with a similar board, but there are too much differences, and the stock BIOS is missing a lot of...11-17-2023, 10:56 AM -
Hi everyone,
I'm trying to recover a Fujitsu Lifebook E5513 (most likely 2023 model) that was bricked during a BIOS update. The update was interrupted (probably due to power loss), and now the laptop is stuck in a boot loop showing "PBB rollback" / "SBB rollback" messages.
BIOS access (F2) and Boot Menu (F12) are no longer possible – the system instantly reboots after the rollback messages.
I extracted the official BIOS update package from Fujitsu (contains FJNB2FD.CAP, ~18.7 MB) and tried tools like UEFIExtract, but it seems to only contain... -
Hello,
I badly need bios dump for HP DM1-4000er,
Model: HP DM1-4000er
Motherboard: DA0NM9MB6D0 REV.D
Product: QJ490EA#ACB
Please help. My bios chip burned so I don't have the old bios anymore. I need bios dump before I can install the replacement. -
The Samsung S49CG934SU monitor does not power on - no LED indicator activity and no response to power button. However, when 21V power is connected, it immediately draws 0.8A of current with no display output. The motherboard processor gets warm, and there is continuous reading activity from the W25Q128BV BIOS chip.
Suspected Cause:
I suspect the BIOS may have been corrupted during a power interruption while updating the firmware. The official website provides firmware updates, but they can only be installed via USB flash drive.
Troubleshooting Attempts:
... -
Hi everyone,
I accidentally bricked my NUC7i5BNH after disabling the option to boot from USB, and now it's not showing any display at all. I tried the USB recovery method, but unfortunately, it didn't work.
Local repair shops are quoting around $150 just to flash the EEPROM, but considering the unit is only worth about $75 these days, that’s not really an option. So I'm hoping to learn how to flash the chip myself. But to get started, I need a working BIOS dump for the NUC7i5BNH.
I did come across a post with a dump for the NUC7i7BNH, but I wasn't sure...
Comment