Hi!
I'm looking for any 80286 based motherboard schematics.
Thanks for any help!!
I'm looking for any 80286 based motherboard schematics.
Thanks for any help!!
-
Hello everyone,
I need the schematics for the motherboard DA00GIMB6H0 Rev : H. It's a HP Chromebook x360. Thanks for your help.
Have a nice day.
Sincerely,
ME06-09-2025, 02:40 AM -
Gigabyte G1 Assasain motherboard Bios IC model needed !
Bios ic fried and I cant read the model on top.
Thanks ! -
My Sparkle (SPI) PC power supply has broken. Originally, there was totally no power output. The 5V-standby was not there. I have replaced a few bulged capacitors but not helping.
I was trying to do more troubleshooting but burned more components. Some got burned so badly that the markings were gone. And also, the markings of a few transistors were gone because the component surface was worn out somehow.
If you happened to have disassembled the same PSU model, please help to provide the markings of some of these components.
See the attached two pictures of the small...09-18-2024, 08:29 AM -
My laptop died on me about two years ago. I went through the basic recovery steps a few times and eventually, after plugging the battery back in for the xth time, a capacitor blew up on the board. Weirdly enough, the laptop then booted (battery removed) and has been running without issue ever since.
I'd eventually like to examine the board in detail however I've had zero luck searching for schematics/boardviews for my particular motherboard.
Any help would be greatly appreciated.
Specs:
MOTHERBOARD: HELA15_N18E_80W (P/N: VF32T 0VF32T CN-0VF32T)...06-17-2025, 04:51 PM -
I think it would be dumb to toss a "modern" motherboard just because a resistor got scraped off, so here I am. I am hoping to find the right schematic so I can see if the motherboard can live without 1 of 3 60B SMDs in series likely scratched off by the backplate of a PCI-E card install or removal. It could be related to a functionality that is not needed or critical, or it could fry anything I plug into it and power on. If I could find a replacement, I could likely pop in on the board, but if I don't need to, then screw it, I don't mind leaving something dark that doesn't matter....07-06-2025, 02:00 PM