PCChips P63G bad flash?

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • protocol
    New Member
    • Jan 2023
    • 6
    • Philippines

    #1

    PCChips P63G bad flash?

    Starting a new thread as advised.
    https://www.badcaps.net/forum/showth...ght=P63&page=2

    I flashed the firmware of H61h2-m2 rev:1.0 BIOS because

    1. I explored the backup dump file and it was written in there.
    2. Some you tube videos say it worked with their P63G in comment.
    3. And it has same chip and firmware version from and H61h2-m2 rev:1.0

    I can still access the BIOS but it is not booting up. Is there a way I could return my previous BIOS backup?

    TIA
  • protocol
    New Member
    • Jan 2023
    • 6
    • Philippines

    #2
    Re: PCChips P63G bad flash?

    Originally posted by protocol
    Starting a new thread as advised.
    https://www.badcaps.net/forum/showth...ght=P63&page=2

    I flashed the firmware of H61h2-m2 rev:1.0 BIOS because

    1. I explored the backup dump file and it was written in there.
    2. Some you tube videos say it worked with their P63G in comment.
    3. And it has same chip and firmware version from and H61h2-m2 rev:1.0

    I can still access the BIOS but it is not booting up. Is there a way I could return my previous BIOS backup?

    TIA
    Fixed by reflashing the BIOS with CH341A from previous thread.

    Comment

    Related Topics

    Collapse

    • ekozeko333
      [Help] Lenovo Yoga Slim 7-14ARE05 (DA0LS3MBAF0) – 25Q80DVN1G Flash Is All FF, USB-C PD Stuck at 5V
      by ekozeko333
      Hi all,
      I’m trying to recover a Lenovo Yoga Slim 7-14ARE05 with board DA0LS3MBAF0 Rev:F. I’ve run into an unusual issue where USB-C PD is stuck at 4.7–5V and the system won’t boot (keyboard lights flash briefly, then nothing).
      🔥 The Problem Started After Suspected ESD/PD Fault
      I experienced a power issue or ESD event through a USB-C charger
      After that, the NX20P5090 power switch was visibly burned and was replaced
      Now the PD controller always negotiates 5V @ 2A, even with known-good chargers
      🧠 What I’ve Done So Far
      Flashed...
      06-21-2025, 02:48 AM
    • corrize
      Nikon D800 camera - flash don’t work and capacitor don’t charge
      by corrize
      Hello, I'm stuck in troubleshooting…
      The flash system works like that : when the (mechanic) flash button is pressed, the flash mecanically pop up, and a circuit buck boost elevate 7v (batt) to 200-300v (?) for charging the big capacitor. And when the photo shoot button is pressed, the capacitor is discharged in the xeon light.

      In the D800, there is a first « power board » close to the battery. 2 wires (batt 7v) goes to another little « flash board ». I measured 7v, so ok.
      When I press the flash button, it's detected by the system, flash icon appear on LDC display....
      10-01-2022, 10:02 AM
    • abajor
      Canon VIXIA HF S10 A read data from inernal flash memory.
      by abajor
      Hello I've had somebody bring in one of these charming little cameras to attempt retrieving data from the internal 32GB flash.
      Something is damaged inside the cameras lens assembly I can hear it clunking around and it has probably dislodged the sensor, powering up the camera gives a blank screen and the focus motor sounds like it's having a fit.
      The camera will not connect to a computer via USB in this state, I have no options no navigation, just power up and focus/zoom motor noises.

      I think my best shot is to figure out a way to read the internal flash memory outside...
      07-20-2024, 12:04 AM
    • Ihandyrepair
      4 red flash led 65X950G boot Sony and android logo but then black
      by Ihandyrepair
      HI guys

      I got here a Sony 65X950G - I tried to find any repairs guides for this model but not many online

      here is the issue
      I have Sony and android logo. but then 4 led red flash lights front of the tv

      I have 3.3v ref. 12v reg then T con 12v when I press the power on button
      but then I get black screen and 4 red flash light at the front LED
      but I get 3 led flash on the LED driver board.

      I check that few X900F or C YouTube repairs, seems that if you have 4 led red flash it could be due of LED black light error
      so I tried...
      07-11-2024, 01:45 AM
    • abhorsen
      Help Disabling Flash Protection Range Registers on Lenovo P360 Tiny BIOS
      by abhorsen
      Hey guys,

      Hope you all are doing well. I come here from Win-Raid because I am having issues disabling Flash Protection Range Registers so I can flash my BIOS from within Windows using Intel's IFW tool/using flashrom within Linux, however I cannot due to the above mentioned error.

      Here is my thread on Win-Raid detailing the whole process I went through: https://winraid.level1techs.com/t/re...h-gen/95478/27

      Essentially I managed to boot into Windows while shorting PINs 1+5 of my audio chip to disable the HAP bit...
      07-06-2023, 10:22 AM
    • Loading...
    • No more items.
    Working...