Frozen screen on Asus P8P67-M PRO motherboard

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • diegito11
    Senior Member
    • Jul 2016
    • 94
    • España
    #1

    Frozen screen on Asus P8P67-M PRO motherboard

    good companions, I have a rare case to tell you to see where to attack.
    It turns out that I have an Asus P8P67-M PRO version 1.0 board that turns me on and gives video and I enter bios but when it comes to installing an operating system, it always hangs either in the installation or once finished, I have tried with Windows 10 and W.7, I have changed the pendrive and it continues to fail me, I have even installed a W 10 installation of a hard disk that I use on many boards to see that it works and it gives me video, just for checks and there it starts windows but After a while it crashes, it is not a blue screen but the screen is frozen.
    I have changed bios battery, hard disk, power supply memories and reprogrammed bios, but I have the same problem.
    Could it be a problem with the pch?
    Last edited by SMDFlea; 12-22-2021, 04:45 PM. Reason: Asus P8P67-M PRO
    Tags: None
    Previous template Next

    Related Topics

    Collapse
    • jean luc ferre
      display screen problems after changing motherboard
      by jean luc ferre
      Hello,
      First on my laptop i had a motherboard with a pentium 6100 processor. Installing w11 i was blocked on the 23h2 version...impossibility to upgrade toward 24h2 because the SSE4.2 functionnality of the cpu was missing. About displaying and screen looking all was perfect.
      I changed of motherboard with an intel I3 processor...and now i don't find the previous aspects of the displaying.
      Now i have a veiled screen and pixels are missing though the graphics parameters have not changed.
      Desinstalling and reloading the drivers in the same time on the graphic card (intel hd...
      09-11-2025, 10:28 AM
    • dhenion
      Asus VivoBook F510UA-AH51 won't run on battery after motherboard replacement
      by dhenion
      I'm working on my sister's laptop: Asus VivoBook F510UA-AH51 - The motherboard died so I replaced it.

      The original board was:
      ASUS X510UNR REV 3.0 A

      The replacement board is:
      ASUS X510UNR REV 3.0 B (identical except B vs A - I couldn't find an A board anywhere. Visually they are identical.)

      It boots right up on the replaced motherboard and everything works fine on the new motherboard - but it won't run off battery. When I disconnect the charger it immediately dies. When I plug it back in and reboot the system - it still shows the battery at...
      1 Photo
      01-30-2024, 01:45 PM
    • Archimedes
      HP Envy 17-3290NR 3D Blank Screen - motherboard Louis V1.1 6050A2489901
      by Archimedes
      Subject is a blank screen issue in HP Envy 17-3290NR 3D version laptop with motherboard Louis V1.1 6050A2489901 MB-A02. Production year is 2012. This one is a 2nd hand motherboard which I could use it for few months only. Suddenly no output from the internal display and also no signal from HDMI port then Windows out of order after few boots.

      Caps lock working normally and no HP's caps-lock warning blinks. Making a hard reset and replacing the RAM sticks or using different slots didn't help.

      Fans are spinning. Blindly could install windows11 and got the device manager...
      07-30-2024, 05:14 PM
    • momaka
      ASUS P5GC-MX motherboard recap
      by momaka
      Here’s another motherboard that needed a full recap: an ASUS P5GC-MX.
      This one was gifted to me some years ago by user Pentium 4, along with a few other goodies. It actually came in working order with no bulging or leaking caps. However, I noted there were United Chemicon KZG caps everywhere on the motherboard. The CPU VRM output (CPU V_core) was the only exception: it had only 2x KZG. The rest was 6x UCC TMV 4V 680 uF caps… which aren’t any good news either.

      So here is what the motherboard looked like with its original caps:


      CPU VRM area up close…...
      01-27-2021, 11:59 PM
    • Stanley1843
      Motherboard W26361-W84-X-02 - Black Screen
      by Stanley1843
      Hello to everyone.
      My W26361-W84-X-02 motherboard starts but don't show image (no logo screen neither bios). Because, I have two of them I desoldered the bios chip from the no working motherboard and I soldered it to the working motherboard and the motherboard works OK, so the bios firmware isn't the problem. Below I took some measurements from the no working motherboard when is power on. Also, I replaced the RAM and didn't work again (maybe some pins from the RAM slot don't have the right voltage?). I replaced and the bios battery, and I made reset on the bios and again the problem didn't...
      1 Photo
      05-23-2024, 03:51 PM
    • Loading...
    • No more items.
    Working...