Re: Apple 27" Cinema Display (A1316) has trouble turning backlight on
in the link above he also says in that post that, to connect only to 2 ends of some 3v resistors, that the third channel is not used, which is a mistake, because the inverter has 3 channels, 3 bars that go up to about 80v when pwm is forced to a maximum of 3 volts, why do I say that? today I struggled again and I managed to turn on the monitor only if I connected the third contact, I think it had a faulty channel or part of the LEDs to say that it was in error, finally I solved the problem without leaving that change, I had imperfect contacts inside the display, at the connectors of the led strips, I had to undo my eyes, working until about 30 minutes ago
what he was saying
,, The led driver is a three channel pwm controller and the board contains all components for three channels and the connector is prepared for three channel but channel three is not used! So don't put 3.3 on R1133! In this case the led driver detects an error and switch off. The led cinema display has only two led stripes! Therefore connect only R1135 and R1132 with 3.3 volts.
thank you
https://i.postimg.cc/J7NYnvdY/P-2020...4-v-HDR-On.jpg
https://i.postimg.cc/bNL60bPQ/P-2020...4-v-HDR-On.jpg
https://i.postimg.cc/CxQmXgz5/P-2020...5-v-HDR-On.jpg
https://i.postimg.cc/0yQVVQ5h/P-2020...7-v-HDR-On.jpg
https://i.postimg.cc/HsTZ7zqY/s-l1600.jpg
in the link above he also says in that post that, to connect only to 2 ends of some 3v resistors, that the third channel is not used, which is a mistake, because the inverter has 3 channels, 3 bars that go up to about 80v when pwm is forced to a maximum of 3 volts, why do I say that? today I struggled again and I managed to turn on the monitor only if I connected the third contact, I think it had a faulty channel or part of the LEDs to say that it was in error, finally I solved the problem without leaving that change, I had imperfect contacts inside the display, at the connectors of the led strips, I had to undo my eyes, working until about 30 minutes ago
what he was saying
,, The led driver is a three channel pwm controller and the board contains all components for three channels and the connector is prepared for three channel but channel three is not used! So don't put 3.3 on R1133! In this case the led driver detects an error and switch off. The led cinema display has only two led stripes! Therefore connect only R1135 and R1132 with 3.3 volts.
thank you
https://i.postimg.cc/J7NYnvdY/P-2020...4-v-HDR-On.jpg
https://i.postimg.cc/bNL60bPQ/P-2020...4-v-HDR-On.jpg
https://i.postimg.cc/CxQmXgz5/P-2020...5-v-HDR-On.jpg
https://i.postimg.cc/0yQVVQ5h/P-2020...7-v-HDR-On.jpg
https://i.postimg.cc/HsTZ7zqY/s-l1600.jpg
Comment