Have a Dell ultrasharp U3014 monitor. One day it just stop displaying properly. POwer supply board looks ok:
Processor board:
[/URL]
You can see a shadow where the dell menu pops up (on the right).:
Attached the photos.I have replaced the T-con board. same results.
I tried removing the narrower cable(with the wider cable still attached) going from the processor board to T-con board and got this:
I tried removing the wider cable(with the narrow cable still attached) going from the processor board to T-con board and got this:
I was wondering if the processor board is sending garbage to the t-con. So should I replace the processor board or is it the panel is faulty? Any advice is appreciated. Thanks.
Processor board:
[/URL]You can see a shadow where the dell menu pops up (on the right).:
Attached the photos.I have replaced the T-con board. same results.
I tried removing the narrower cable(with the wider cable still attached) going from the processor board to T-con board and got this:
I tried removing the wider cable(with the narrow cable still attached) going from the processor board to T-con board and got this:
I was wondering if the processor board is sending garbage to the t-con. So should I replace the processor board or is it the panel is faulty? Any advice is appreciated. Thanks.
Comment