Have replaced inverter board caps with no change.
I checked the "272" SMD resistor on the usb board (the one covered by goo) as others have done (I first saw it in this thread https://www.badcaps.net/forum/showpo...4&postcount=10), and it reads a nominal 2.8K. However the SMD component next to it reads open—not sure if that's an issue.
I also measured transformers as described in this post:
https://www.badcaps.net/forum/showpo...6&postcount=14
All readings are nominal ~ 1.06 but one is ~1.25. Is that an issue?
I have not measured voltages, can someone point me to the best place to do that?
Board P/N 5EL2J02001 - I can post pics tomorrow if that is helpful.
I checked the "272" SMD resistor on the usb board (the one covered by goo) as others have done (I first saw it in this thread https://www.badcaps.net/forum/showpo...4&postcount=10), and it reads a nominal 2.8K. However the SMD component next to it reads open—not sure if that's an issue.
I also measured transformers as described in this post:
https://www.badcaps.net/forum/showpo...6&postcount=14
All readings are nominal ~ 1.06 but one is ~1.25. Is that an issue?
I have not measured voltages, can someone point me to the best place to do that?
Board P/N 5EL2J02001 - I can post pics tomorrow if that is helpful.
Comment