Car Audio Amplifier Bose How to turn it on

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • skynet85
    Senior Member
    • Jul 2015
    • 124
    • Georgia
    #1

    Car Audio Amplifier Bose How to turn it on

    I am have 2012-2015y FIAT 500 Audio Amplifier Bose OEM 3284780030
    when connect the power to pin C4 + and pin C8 - it does not react, I think that you still need to use some kind of contact to turn it on, I found the pinout but I can't figure out what to use
    Attached Files
    Tags: None
    • stj
      Great Sage 齊天大聖
      • Dec 2009
      • 31002
      • Albion
      #2
      Re: Car Audio Amplifier Bose How to turn it on

      the pin marked "remote" probably needs 12v or ground to power it up.
      a bigger concern is the GPIO inputs
      it may switch the number of speaker outputs based on what car it thinks it's in.
      also - PWM???
      maybe it monitors the cars speed to ajust the volume

        Comment

        Previous template Next

        Related Topics

        Collapse
        • FALKLAN
          Mercedes-Benz W163 Bose Audio System
          by FALKLAN
          Howdy everyone!

          I have a SUV with a Bose audio system and I'm considering either a system upgrade, or purchasing a complete replacement system while bypassing the integrated Bose system.

          On the Bose side, I have not found any specifications yet. It's a decent system but I'm, at a minimum, replacing all the factory speakers, head unit and adding an amp and two 8" subs. The Bose is a 2ohm system and I'm not certain about this point. In order to use a 4ohm set of speakers (component/loud), I would need to install 2 sets of 4ohm speakers wired in parallel to match the...
          12-07-2023, 11:22 PM
        • samson7point1@yahoo.com
          Help troubleshooting an audio problem with an RCA SGT-250 CED Player
          by samson7point1@yahoo.com
          The Problem: This player has a toggle switch to select between Stereo, Mono R, and Mono L. Regardless of the setting it outputs the sound to both the L&R audio jacks. In the Mono R position, the audio output level is normal (from both the L and R audio output jacks), in the Stereo position the audio output is about half the volume, and in Mono L, it's about 3/4 the volume. Something about putting it into Stereo mode is causing the volume to drop significantly and I can't figure it out.

          The player processes the audio signal using two different reference frequencies. The "R"...
          PW300S circuit diagram
          2 Photos
          04-30-2024, 11:22 AM
        • eccerr0r
          Frying amplifier finals... audio, not rf...
          by eccerr0r
          Well for RF transmitters, transmitting without an impedance matched antenna and if the transmitter doesn't have automatic limiting... kiss the final transistor goodbye and chalk one up to something you killed.

          But that's not the same way with audio amps for the most part, well, at least the wavelength of audio on copper is so long that you get all of it back anyway but the transistor is fine with it...

          So how are people destroying finals in their audio amplifiers then? Heh.

          Are people shorting their outputs or something, overdriving output to a too big speaker?...
          11-27-2021, 12:30 AM
        • Babbar
          Argon SA1 audio amplifier power-supply - fuse blown after fixing the short?
          by Babbar
          I found a project in the electronics trash yesterday. A nice Argon SA1 audio amp with some electrical issue. Took it apart and saw that the 4A250V fuse was blown so started lifting components to find the short. Eventually got to two MOSFETs (model FTA14N50C) that are shorted and when i took them out the short was gone.

          Now i didn't have any replacements of the same model of course but i found a couple with pretty similar spec i thought (K10A60D & K12A50D) and put them in. Also replaced the blown fuse with a 3.5A250V one. Checked another time for short circuit and plugged it in....
          04-12-2024, 01:12 AM
        • Marek011
          Help in recognizing the components on the BOSE amplifier board
          by Marek011
          Hello, I have a problem recognizing the elements marked with blue dots, unfortunately BOSE does not provide any boardview. What could it be? Foil capacitors?

          BOSE board number: 283394-001

          Thank you...
          03-25-2024, 08:24 AM
        • Loading...
        • No more items.
        Working...