Another Yamaha

[R_J]

Re: Another Yamaha

The standby led supply voltage is the +3.3M It can be tested on operation board plug CB473 (page 136) There is also the control line from the main microprocessor ic which is the pin next to it, it should change when the amp goes from operate to standby

[No1baggiesfan]

Re: Another Yamaha

I'll test that tomorrow, but for now it seems to be ok, it's working at least.
One other issue I noticed is that when I press 'sur decode' it goes into 'straight' mode when it should go into 'neo' mode

[R_J]

Re: Another Yamaha

Try doing a full reset, if that does'nt help check the firmware version, I see there is a firmware update to ver. 1.80

[No1baggiesfan]

Re: Another Yamaha

Firmware is already 1.80
Just turned the amp off, red standby light is now on lol ??

[R_J]

Re: Another Yamaha

Thats likely how it works, standby led lit in standby, turns off when amp is on.

[No1baggiesfan]

Re: Another Yamaha

It does, but it it hadn't lit since last week

[No1baggiesfan]

Re: Another Yamaha

Update.
Looks like she's back to her old self again, everything is working as it should, watched a couple of movies, no issues, does seem to be a tad warmer than I remember, maybe it's just me being paranoid lol.

Anyway, want to say thank you again to R_J for his time and help and everyone else who also joined in.

[No1baggiesfan]

Re: Another Yamaha

Update again.
Amp still working, yay
Now I need to fix the on/off button on the remote, :/