Hello everyone, I have a lot of demo acton iii speakers. When I plug in the speaker, it lights up automatically and can only use aux. I want to use it normally. Is there any way? Thank you.
-
Hi,
My column Marshal Acton 2 , is dead . Power suplyy is it ok ... 18 V , but not light and not power on.
In board off buttons dont have 3,3 V - see picture .
I need some help, and i try to find schematic !
Do tou can help-me ?
Best regards... -
Hello Guys! I have trouble with my car radio Kenwood KDC 3051G I hope someone more knowledgeable can help me, I tried everything in my power that I stumbled upon online.
My radio is permanently in demo mode, it says Press Volume Knot Cancel Demo and when I press it nothing happens.
- Tried to unplug radio and plug it back in into power,
- Tried to reset radio by holding reset button key for 5,10,30 seconds while in power and without power, plugging it back in, it wouldn't work.
- Tried to hold 3,6 while turning it back on and then pressing 1,2... -
Laptop Model: DELL Precision 3520 Motherboard: CDP80 LA-E152P Rev 1.0 (A00)
Issue: The laptop powers on automatically after being shut down.
Actions Taken by Technician:
BIOS reflashed
Intel ME region cleared
Result: Issue still persists
Additional Observations:
Power button reads 3.3V (normal)
The problem occurs both when running on battery and when connected to AC adapter... -
Hi, recently i have encountered problem with my Marshall stanmore multi room speaker, speaker itself works fine using app from my phone but knobs on actual speaker doesn't work. First thing that came up to me is that maybe something is shorted on the top board and after disassembling the speaker and checking with multimeter I could not find anything wrong, also on the panel multi, and next song button are working and nothing else. Any help is very appreciated​...03-24-2025, 08:37 AM -
Hisense H60N5705 installed in a conference room, turns off automatically a few minutes after being switched on.
Problem occurred suddenly, during a video conference. Switched on again by the remote control, it continued to work for a while and then switched off again.
Power cable and HDMI cable checked.
No changes by connecting the TV to another source but, even if it is left on the OSD menu, it stays on for a few minutes and then switches off.
So they took the TV (a 60' which is not easy to handle) to the lab and asked me to check it.
...