i need sm hi-fi TEAC CR-H130
thanks
thanks
-
Hi I have an old Teac CR-H100 hifi that has a leaking and worn out backup battery. I was looking for a suitable replacement component. Would something like this be ok:
https://www.ebay.co.uk/itm/362488422916
Seems to be the right size. It it NiMh but the original is NiCad but I can't seem to find any NiCad type replacements.... -
Hi All,
I have the above mini HiFi that after powering displays the standby LED and when the power switch is pressed the relay momentarily clicks in then cuts out again.
I've included an image of the power board schematic.
There is 5.9V present on pin 4 of CN507 and when the standby button is pressed 2.6V momentarily appears on pin2 of the same connector.
Any thoughts would be welcome.
The service manual exceeds the Badcaps file size limit but it can be found here:... -
Hi All,
I'm trying to repair a Sony CMT-SPZ90DB compact HiFi that includes a 3-disk CD, cassette & tuner.
When it's plugged into power the red LED illuminates but when the Standby1/0 button is pressed it briefly starts up with CD & cassette motors starting but then goes back into standby.
The power board shows signs of heat and a picture is included as is the service manual.
I've been doing a quick check of a some componants in the PS board and came across D602 which is open circuit.
Off the board it's still reads o/c.
... -
Hi guys,
I have a Teac LCD [Model: LE5050FHD] with an issue.
As soon as it's powered on, the TEAC splash screen loads and then the green power light flashes from green to red over and over for 10 or 15 seconds. The TV then restarts. This loop seems infinite.
I cant seem to find any firmware for this model to update, if is does exist.
Whats the next step? Take the back off and look for blown transistors someplace?
Thanks in advance,
Steve -
Hi everyone. I'm new on this things, this is my first amplifier after I start offering repair service almost for free, just for learning purpouse
So I have a amp that is going to protection mode. I saw that if I remove the ribbon cable which sends from main board B+,B- and signal for amplifiers card, is not going to protection mode.
So, from that ribbon cable y disconnect everything but b+ b-, and amp goes again to protection mode. So my guess was something is wrong in the amp board.
I disconnect all transistors and amp is ok.
After, I connect the...