Announcement
Collapse
No announcement yet.
User Profile
Collapse
-
So...i´m going to check this relay... is the only thing that i see which is related with channel 1 and 2...if the coil is burnt...could cause a failure....1 Photo
-
TEAC AG 980 going protection mode
Hi everyone. I'm new on this things, this is my first amplifier after I start offering repair service almost for free, just for learning purpouse
So I have a amp that is going to protection mode. I saw that if I remove the ribbon cable which sends from main board B+,B- and signal for amplifiers card, is not going to protection mode.
So, from that ribbon cable y disconnect everything but b+ b-, and amp goes again to protection mode. So my guess was something is wrong in the amp board.
I disconnect all transistors and amp is ok.
After, I connect the...
-
Re: New Members - please post your introductions here
Hi everybody,
I´m starting on electronic repairs. I jsut get motivated after seeing how Sorin works in "electronic repair school" in youtube, very recomendable channel. I think the most real channel about repairs. Very dodgy!
Hoping I´ll be helped here, and someday, y hope I´m going to be able to help someone!
Best regards to everybody
Leave a comment:
No activity results to display
Show More
Leave a comment: