-
-
Re: Blomberg electric dryer - Need a replacement relay
I replaced the suspect relay with new, but it made no difference. The control board I ordered over a month ago is still out of stock. Any leads to an appliance parts salvage are welcome.Last edited by steves7839; 10-30-2022, 08:52 AM.Comment
-
Re: Blomberg electric dryer - Need a replacement relay
have you pulled both relays out and tested them ? did you ohm the wires off the relay that go to the coil for proper resistance ? dryers are fairly straight forward - easy to repair.
please post model #
there's one on EBAY https://www.ebay.com/itm/194280574677
marked washer but its a dryer control board that seems to be the one you need
another one cheaper - https://www.ebay.com/itm/19381880177...Bk9SR6rHnKGFYQLast edited by ajshoe; 10-30-2022, 12:08 PM.Comment
-
Re: Blomberg electric dryer - Need a replacement relay
did you check for any thermo-switches usually fitted as a final safety?Comment
-
Hello everyone,
I'm turning to the Badcaps community to help me troubleshoot the radio Rx card from my (old) garage door opener. While I could just ditch that card and replace the whole system, I first would like to understand "why" it suddenly stopped working, because that's just how I am wired...!
Some basics: the receiver works on a 30.875 Mhz frequency. Yes, I'm aware this is not in use anymore in a looot of places. It does not use any rolling code, it's just a regular dip-switch code that you have to set up on both the receiver and transmitter. The receiver... -
Hello,
I'm helping my brother to fix his Blomberg laundry dryer. He called a repair guy to have a look and the repair guy said the control board is faulty. They said the replacement board costs $400. Too expensive! 😨 My brother asks me to take a look. He has checked the door switch and thermal fuse, etc., and those seems fine.
After plugged to mains, there is no display. There is just a clicking sound from the buzzer, like one click per second. No other response.
I suspect the firmware inside the MCU (ATMEGA64A) got corrupted. Can someone in this forum by any chance provide... -
Actually this range had multiple problems but I fixed all the others already.
I am stuck finding a replacement infinity dual burner switch for a Kenmore C970-605121. The dual burner is stuck full on as soon as you turn the knob either side, either the difference of either only one or both burners running full tilt.
I tried cleaning it inside contacts, but that didn’t do anything.
I believe the dual burner switch reads a part number of: 318191021 which is hard to find. I came across a 318191026 part number but it has 2 pins on the row missing. Is there anything... -
Hello. I have Industrial Washing Machine PCB.
Customer Requested Relays Replacement.
I can't find WJ115F1 relays to buy. Looking for some help to identify possible alternative solutions.
Or any tips, on how to approach this situation.... -
I picked up a Panasonic NH-P70G2, though it would apply to the NH-P80G2, NH-P70G1 and NH-P80G1 models as well, as maybe some other models. This one was coming up with a H86 error. After lots of testing and googling it was an error with one of the thermistors in the condenser area.
The attached French service manuals is incorrect, TH11 is gray and is a 95k thermistor and TH12 is black and is a 35k thermistor.
In my case TH12 was bad. I was able to get a 35k thermistor on AliExpress. It's 6mm in diameter.
Unfortunately the whole machine has to come apart to fix it.
I have...Yesterday, 06:40 PM
Comment