How big problem are insects for power supply?

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • LearningToRepair
    Member
    • Jul 2020
    • 35
    • *

    #1

    How big problem are insects for power supply?

    If power supply has ventilation holes from which insects can enter, and it is near the lamp - that means insects are attracted. How bad is it? I found that my ceiling light's built in power supply had a ton of insects inside and in this case it did not seem to cause problem. But how is it in general?

    For example one of the worst case scenarios would be


    Or a little bit better would be:


    Will they cause arcing with 230V AC?

    If it is known that it's gonna attract insects is IP67 the only option or are these kinds of power supplies fine also? Indoor use can be assumed. The source of insects is simply open window during summer months.

    Here is realistic expectation of insects:
    Last edited by LearningToRepair; 11-08-2021, 05:48 PM.
  • eccerr0r
    Solder Sloth
    • Nov 2012
    • 8696
    • USA

    #2
    Re: How big problem are insects for power supply?

    that's a very buggy design...

    Mostly it's whether its ventilation is acceptable when bugs clog it up. The bugs will dry out and be insulative for electricity so that's ok but it will clog up airflow, possibly causing overheating. Some PSUs may not even need the vents. So really it depends, but adding some baffle to prevent bugs from entering would be prudent.

    Comment

    Related Topics

    Collapse

    • sam_sam_sam
      Desoldering gun station modified to use a 18 volt @ 20 amp switching power supply
      by sam_sam_sam
      I have wanting to do this project for quite sometime now and I finally found a switching power supply that will work on this desoldering gun station ZD-915 that the original switching power supply took a shit and just was not worth trying to fix it because this switching power is not quite big enough to handle the heater element and the vacuum pump

      One note when I tested the switching power supply and the voltage control board I noticed that this desoldering gun heat up much faster than the original switching power supply which I was really surprised by to the point that I might buy...
      03-31-2024, 02:12 PM
    • sam_sam_sam
      Modification to a ZD-987 desoldering/soldering station using a external switching power supply
      by sam_sam_sam
      I have been working on this concept for quite some time now with limited success but recently I found a switching power supply that is setup for the voltage that this soldering station needs to operate at however it also needs part of the secondary circuit from the original switching power because you need several voltage rails

      I once tried to get a ZD-915 desoldering station to work on a 18 volt battery power supply but unfortunately things did not go well but I did find a work around but I might try this idea again but going at a little differently more about this another time...
      07-01-2024, 06:34 AM
    • Tynan Dill
      Vizio e601i-A3 - Has Sound and Display, But No Backlight - Bad Power Supply Board or Bad LED Bulbs ?
      by Tynan Dill
      I was given this TV from my great uncle. He said it just wouldn't turn on one day out of nowhere, replaced the TV, and gave it to me to possibly fix and use for myself.

      Upon bringing it home and plugging it up, it showed a standby light.

      I powered it on and without a flashlight, the display showed the "V" but the lighting is very dim, but visible.

      The screen seems to blackout and stay black, but with a flashlight I can see the display.

      With my Playstation 4 connected via HDMI, and running a game I can hear sound.

      Assuming...
      11-22-2024, 01:46 PM
    • JimBanville
      Definitive technology SC 2000 subwoofer amp's power supply clicking and popping
      by JimBanville
      The sub developed a constant popping every couple seconds from woofer and power LED flickering with nothing but wall AC connected. Connecting an audio cable didn't change anything. It doesn't play but a second or two of audio in between the pops.
      Opened it up and discovered the power supply is making a faint clicking or ticking sound.
      I measured the amp's output to the woofer and it pulses up to 50mv DC to be driver. The pulses coincide with the power supply ticking/clicking.
      I measured the power supply output going to the amp board and it too has this pulsing. Voltage cycles...
      09-13-2023, 07:21 AM
    • shamsudeen
      Hi, Can we use SMPS Bench Power Supply for Laptop troubleshooting?
      by shamsudeen
      Hi all, I just need to know that, can i use SMPS type power supply to test and short circuit detection on a laptop motherboard?
      I saw 95% of repair guys are using only Linear bench power supply. linear bench power supply is pricy, thats why i planned to get one SMPS supply.

      i know that in linear power supply the noise will be very low comparing to SMPS supply....
      Yesterday, 07:14 AM
    • Loading...
    • No more items.
    Working...