-
-
Re: PTC plate heater Feadback required if possible
that's tiny, it's just for melting glue on phone cases. -
Re: PTC plate heater Feadback required if possible
Would it work for LED light strips
Because I have a lot of them I want to harvest and or mod them in a different configuration or at least attempt it anyway
I have bought some these a couple times when they have been 50% off sale ( which they have not done in a while)
The lot of 20 and the lot of 50
https://www.goldmine-elec-products.c...number=G21005BLast edited by sam_sam_sam; 04-19-2019, 09:23 AM.Comment
-
Re: PTC plate heater Feadback required if possible
Believe It or Not, picture one (fast, succinct, power-saving and controllerless) better than picture two (with PID controller).Attached FilesLast edited by capwizard; 04-19-2019, 10:07 AM.Comment
-
-
Hi!!
Yesterday I was installing a new Wifi thermostat for my domestic gas water heater model Vaillant 242/2-3, and accidentlly one wire from mains touched one wire from the thermostat output contacts. This shut off the heater so I finished installing the thermostat and then went out to check the heater
I found one fuse blown (T2 250V). Replaced it with another equivalent fuse and it blew right away. I measured L-N in mains input and I sometimes got 4K but sometimes, not sure why, I got 100 Ohm...
At a certain point, moving stuff around, I put all wires back in place and... -
Hello everyone.
Some background - I have one of those chinese diesel heaters, which I'm using to heat a garage. Probably most of you are familiar with that units, but here is some basic info - the main heater body is enclosed with the motherboard+sensors unit inside a plastic case. The heater has a glow plug, that works only when the unit is starting (start the fire in the burner) and stopping (make sure to completely burn the fuel inside the burner) and two fans on a single motor. One fan is used to push fresh air in the burner, the other is used to push cold air in the case and... -
I was Ollie today which is a close out / surplus outlet store I do not go in there to often because you find things that you should not be tempted by but that is a another story
I saw a small space heater that used a wire type of heater element which I been looking for a while but not really hard mind you but when I saw this I grabbed it I going to go back tomorrow and buy the last one that is like the one I bought today because I need the heater element and the ceramic insulators and more of heat element wire because this one has two different wattage settings one 1300 watts ( tap... -
Hi guys. I have an question. Overall i am currently selling my house ( apartment with 1 room ) to buy some cheaper with 1 room too, and save cash for new pc in autumn 2024.
So i choosed some cheaper apartment in smaller city,but there is coal heating. I dont wanna heat for coal.
So i m thinking to buy electrical heater. And my question . Is this any sense to buy electrical heater when i will be using new pc with rtx 5090 and new intel ( when will be released ) ultra + Psu Seasonic 1600W?
I expect that i will pay more for bills. But i wanna know this. Will using electrical... -
I was attempting to replace the LED lights on an Edge-lit Samsung UN55NU7100...While removing the sheets and the light diffuser plate which already had cracks at the bottom. The plate bent(more than I'd like) and broken in half.
1) Is it still usable if I can put in back into place
2) or Do I have to find a replacement diffuser plate and can it be any diffuser plate from a 55" Samsung LED TV or specific to my model?
3) can a new plate be purchased from Samsung?
Comment