Hello

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • Venomus28
    Member
    • Oct 2016
    • 38
    • Albania
    #1

    Hello

    I have a question and im sure i'd get some help on here
    Recently i got a broken UPS open it up and found out the battery is bad, its a 12V and 4.5Ah
    Anyone has any clue what is the max wattage this UPS can handle ?
    I've checked for any label but didnt found any
    Tags: None
    • budm
      Badcaps Legend
      • Feb 2010
      • 40746
      • USA
      #2
      Re: Hello

      Make, model, picture will help.
      Never stop learning
      Basic LCD TV and Monitor troubleshooting guides.
      http://www.badcaps.net/forum/showthr...956#post305956

      Voltage Regulator (LDO) testing:
      http://www.badcaps.net/forum/showthr...999#post300999

      Inverter testing using old CFL:
      http://www.badcaps.net/forum/showthr...er+testing+cfl

      Tear down pictures : Hit the ">" Show Albums and stories" on the left side
      http://s807.photobucket.com/user/budm/library/

      TV Factory reset codes listing:
      http://www.badcaps.net/forum/showthread.php?t=24809

        Comment

        • Venomus28
          Member
          • Oct 2016
          • 38
          • Albania
          #3
          Re: Hello

          Update
          I found out my other UPS an "Inform GUARD" On battery pulls out 160V
          What should i check ?

            Comment

            Previous template Next

            Related Topics

            Collapse
            • MyBrainIsAStrainer
              Quicko T12-955 Repair (Board Rev 3.3): Help identifying components needed
              by MyBrainIsAStrainer
              Hello! I'm newbie-ish in electronics and hope you can help me.

              I use a Quicko (or Quecoo, not sure which is correct) T12-955 soldering station as my daily driver. Recently, I had a mishap. While changing tips, the metal contact inside the handle got bent and must have shorted against some other contact. Since then, the station only shows "Error" on its display. I fixed the bent contact but the error didn't go away. In fact, now it's completely dead.

              After opening it, I found obvious two faults: A chip that looked molten (U5), and another chip which got very...
              06-17-2023, 10:59 AM
            • deviantcode
              I have a thinkpad p1 gen 3 20th-ct01ww. Recently I've had 2 that after windows updates, it no longer detects the battery
              by deviantcode
              I have a question regarding one of these lenovo laptops. I have a thinkpad p1 gen 3 20th-ct01ww. Recently I've had 2 that after windows updates, it no longer detects the battery. I have tried rolling back the bios update and that didnt fix it. Is this something that requires modifying the original bios to fix or is it bios related at all ? Is this issue common. thanks.
              ​
              01-31-2025, 08:56 AM
            • danny34
              Thinkpad E15 Gen2 Intel "lower wattage AC Adapter"
              by danny34
              Hello folks,

              My Thinkpad E15 Gen2 with i7 had stopped loading and wouldn't start either. I noticed the typical error with the Mosfet QB6. This has become unsoldered.

              I soldered it back on and found that the gate voltage was too low and that's why it was getting hot. Then I wanted to replace the UB7. Unfortunately the one I ordered from China didn't want to run.
              So I soldered the old one back in and it still has its 18.9V at the output of QB6.
              I stuck a thermal pad on the QB6 to cool it down a bit.

              Now the E15 is running again, but unfortunately...
              10-30-2024, 02:10 AM
            • Stefan Steff
              HP laptop smart PSU wattage
              by Stefan Steff
              Is there any software/program what recognize the PSU wattage attached to a HP laptop?... like DELL has in BIOS/Battery status...?
              Thanks!
              S.S.
              08-05-2024, 06:29 AM
            • Hondaman
              Liquid cooling?
              by Hondaman
              I hope my computer does not randomly reboot while typing this. My main system is the AsRock 970A-G/3.1 motherboard with the AMD 8150 chip. I am experiencing FREQUENT and RANDOM reboots once the system is used for a couple of hours (sometimes it reboots before I even get to the Win7/Linux Mint dual-boot screen). The problem MIGHT be the DRAM controller chip (I recently upgraded to the maximum 64 GB RAM). It also might be the VRM chips. I am using a typical aftermarket CPU cooler, which does NOT blow air DOWN onto the VRM heat sink.

              (After previous generation hardware [Gigabyte] didn't...
              05-08-2025, 09:37 PM
            • Loading...
            • No more items.
            Working...