Need help to identify and to locate a 0.33 ohms fusible resistor for power supply

[gica69]

I have a quad charger that is split into 4 separate sections and one section doesn’t charge anymore. I have located what I think is a thermistor and on the shrink tube it says 125 degrees C. I cut the shrink tube and it's a 33 ohms resistor. It measures a little less than 1/2 inch in length. I am including pictures of it. Please help me identify it. So, it should test at 0.4ohms and probably go up in resistance with the rise in temp. On the board it clearly says R for resistor. But it has to be a special one.
Resistor shows orange range silver gold and green lines.
Thanks in advance

[gica69]

I also need help identifying another component 85A50D 6 pin IC has a U under it. There is a picture with the voltages on a live circuit. There is diode voltage drop between ground and pin 1,2 and I think 3? I looked for it and could not find anything. It's from the same power supply as above. I really appreciate any help.

[lotas]

85A50D = SC2585A

Regarding the resistor, it is a regular current resistor, its resistance will not increase and it should be 0.33 Ohm.

[gica69]

So it's not a fusible resistor, I also thought about using a regular 0.33ohms resistor but was told it has to be a fuse resistor!1
Any word on the chip I am trying to locate?

[lotas]

Any word on the chip I am trying to locate?

Yes, it's a tough case, I gave you full information on the chip (SC2585A) that you are looking for in post 3.