3d printed electronics bench accessories and equipment

Urshurak776

New Member

Join Date: Jul 2021

Posts: 6

Country: United States
#21

07-13-2021, 02:07 PM

Re: 3d printed electronics bench accessories and equipment

As the OP stated, I printed several items from thingiverse for small parts storage (resistors, diodes, etc.) They work great.
Comment

Previous 1 2 template Next

by BOSCHNJAK

ABOUT ME INTRODUCTION FILE

2024 BEV, BIH, SARAJEVO START PROJECT: ELECTRIC VEHICLE TOYOTA 4 RUNNER CONVERSION http://www.bev.ba/TOYOTA4RUNNER/index.html
2023 BEV, BIH, SARAJEVO START PROJECT: SECRETS AND MANUFACTURING PLANS (AS MY REPLICA) OF THE LIBERTY ENGINE 2.0.
2022 BEV, PROJECT ?
2021 BEV, PROJECT ?
2020 BEV,BiH, Sarajevo: PROJECT IS: HOW TO SWITCH OFF PERMANENT MAGNET FIELD and HOW TO SWITCH ON PERMANENT MAGNET FIELD?
2019 BEV, Croatia, Ston:, Broce: PROJECT - PROJEKT ELEKTRIČNI GLISER http://www.bev.ba/ELEKTRICNIVANBRODSKIMOTOR/indexHR.htm...
- Channel: Visitor Messages
12-28-2023, 02:09 PM
Artist seeking to tinker with electronics safely

by Hypersapien

Howdy folks! I'm an artist in the video game industry, and my job entails making a lot of mechanical and sci fi assets. I thought it might be a good practice to start disassembling some electronics to be more familiar with how real electronics are manufactured and assembled, which is how i found my way to these forums.

When I started researching what tools I might need, I quickly encountered the warning "Some devices can maintain a potentially lethal charge in their capacitors, even up to years after last being powered on", which was enough of a scary thought for me to...
- Channel: General Electronics Technical Discussion
10-22-2023, 01:31 PM
700mv ripple on Akai Sampler linear supply

by sumilumi

Hi fellow troubleshooters. This is my first post on badcaps. I've recently setup an electronics workbench. i'm also building a studio with old equipment bought faulty at low cost.
I've been into electronics since the mid 80's and particularly in the last few years though only getting hands on with repairs now. My knowledge gaps are significant so I'll be posting here to seek guidance advice and general practical applied learning.

On my bench today is an old ca. 1993-95 Akai hardware sampler. This runs on both a linear and Smps supply. Both are getting on in age and ripple...
- Channel: Troubleshooting Power Supplies and Power Supply Design
01-02-2022, 10:12 AM
Hi, Can we use SMPS Bench Power Supply for Laptop troubleshooting?

by shamsudeen

Hi all, I just need to know that, can i use SMPS type power supply to test and short circuit detection on a laptop motherboard?
I saw 95% of repair guys are using only Linear bench power supply. linear bench power supply is pricy, thats why i planned to get one SMPS supply.

i know that in linear power supply the noise will be very low comparing to SMPS supply....
- Channel: General Electronics Technical Discussion
07-19-2025, 07:14 AM
Bench test a series X

by Eniaro

How do you bench test a series X? I was planning to find a defective PSU to use its connector, but before I go about doing this, I was wondering if there's any bench PSU to the series X connector adapter available
- Channel: Troubleshooting Game Consoles & Other Weird Devices
06-17-2025, 01:46 PM
Loading...
No more items.

3d printed electronics bench accessories and equipment

Comment

Related Topics