Atten 8586 Repair Help needed

[blackburnd]

I have an Atten 8586 soldering station at work. Unfortunately I dropped it today and the only part I managed to hold on to was the soldering wand. All the wires ripped out at the connector to the station. I was hoping someone could take a pic or tell me what wires go to which pins. I would really like to repair this unit since the company owner is kind of a penny pincher. Prefer not to buy shop tools out of my pocket. Thanks in advance

[stj]

Re: Atten 8586 Repair Help needed

foto's of the connector please.
i have a lot of pinouts for those, but there are a few different connectors in use!

[blackburnd]

Re: Atten 8586 Repair Help needed

foto's of the connector please.
i have a lot of pinouts for those, but there are a few different connectors in use!

Sorry for the delay. I was off Yesterday.

[blackburnd]

Re: Atten 8586 Repair Help needed

The pins that had wires connected on this connector were 1,2,5,6,7

[R_J]

Re: Atten 8586 Repair Help needed

I found this video which might help identify the wires in the solder iron, I see hakko 907 and the atten 8586 seem to use the same replacement iron.
https://www.youtube.com/watch?v=aVkXNvVu7EQ
and I found this with a pinout for a atten 8502, maybe they are similar
https://www.jackenhack.com/atten-850...-iron-element/

[dellxps15]

Re: Atten 8586 Repair Help needed

ill disassembly mine and take picture.... wait a bit...

edit1: ops i disassembled the solder station not iron... wait

edit2: they are numbered:

1 yellow
2 red
3 nothing
4 nothing
5 blu
6 black
7 green

and here is a picture of the iron wires, as u have different color:

green is gnd

[blackburnd]

Re: Atten 8586 Repair Help needed

Thanks for all the help folks. I got it up and running again.

[mckote]

Re: Atten 8586 Repair Help needed

Thanks for all the help folks. I got it up and running again.

what order of colors you have put. ?
I have the same cables as you.