Need HP 11-K001NX schematic

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • kalilinux25
    Badcaps Legend
    • Mar 2018
    • 2069
    • ZAMBOANGA SIBUGAY

    #1

    Need HP 11-K001NX schematic

    Hi this board has a water damage now the laptop wont charge, i need some schematic to see the connections..
  • anshad
    Badcaps Veteran
    • Nov 2010
    • 249

    #2
    Re: Need HP 11-K001NX schematic

    Board Number ?

    Comment

    Related Topics

    Collapse

    • Tynan Dill
      Vizio e601i-A3 - Has Sound and Display, But No Backlight - Bad Power Supply Board or Bad LED Bulbs ?
      by Tynan Dill
      I was given this TV from my great uncle. He said it just wouldn't turn on one day out of nowhere, replaced the TV, and gave it to me to possibly fix and use for myself.

      Upon bringing it home and plugging it up, it showed a standby light.

      I powered it on and without a flashlight, the display showed the "V" but the lighting is very dim, but visible.

      The screen seems to blackout and stay black, but with a flashlight I can see the display.

      With my Playstation 4 connected via HDMI, and running a game I can hear sound.

      Assuming...
      11-22-2024, 01:46 PM
    • howardc64
      A1312 (27” iMac 2009-2011) A1407 (Thunderbolt Display) A1316 (Cinema Display) Display Black Screen Repair
      by howardc64
      Problem

      This is an LG edge LED lit LCD Display. The LEDs are on the bottom edge of the display. There are 2 bars (left and right) Each bar has many LEDs and a 6 pin connector. Each pin drive several LEDs thus is the highest current flow / heat junction. The weak lead free solder gradually fails with thermal expansion/contraction cycling and increases resistance. PSU will compensate up to a point, then when the current is too high, PSU just shut down the backlight causing a dark display. I have even seen one which the connector just fell off as solder points became completely detached....
      08-04-2024, 10:36 PM
    • EffiSon
      ASUS ZenBook UX3404 Water Damage - Schematic / Boardview / Component detail Needed
      by EffiSon
      Hi,
      I have got a water damage Asus Zenbook UX3404 (exact model no. UX3404VC-PURE5) where one of its component got burned, picture attached. MARKING ON COMPONENT is ONLY 5k6 !!
      Wondering does anyone know what is that component, it is located near the GPU. I have found out the same component near the LVDS cable on and that is how conclude that the suspected burned component

      Thank...
      04-20-2024, 03:33 PM
    • edugimeno
      Vaillant 242 Gas Water heater. Shortcut in board anc compatibility with model 282
      by edugimeno
      Hi!!
      Yesterday I was installing a new Wifi thermostat for my domestic gas water heater model Vaillant 242/2-3, and accidentlly one wire from mains touched one wire from the thermostat output contacts. This shut off the heater so I finished installing the thermostat and then went out to check the heater

      I found one fuse blown (T2 250V). Replaced it with another equivalent fuse and it blew right away. I measured L-N in mains input and I sometimes got 4K but sometimes, not sure why, I got 100 Ohm...
      At a certain point, moving stuff around, I put all wires back in place and...
      03-24-2024, 02:31 PM
    • sam_sam_sam
      Tankless hot water heater controller board not powering up when power is applied
      by sam_sam_sam
      I recently bought a used tankless hot water heater and the controller board is completely dead no power up when power is applied the display board works however the main controller board does not work correctly at all the fuse is good

      I bought a used replacement controller board that also had issues that I was able to fix and now the tankless water heater works correctly now

      However I would like to know if I could figure what happened to this controller board if possible

      Tomorrow I will take some better pictures of both side of both boards

      The...
      12-09-2022, 09:14 PM
    • Loading...
    • No more items.
    Working...