Looking for some fans

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • Maxxarcade
    Badcaps Veteran
    • Jul 2006
    • 973
    #1

    Looking for some fans

    I'm having a really hard time finding a good source some fans.

    I need lots of 50x10mm fans with 10+ CFM, and also some 80x15mm ball bearing fans.

    The usual places I check are out of stock on anything decent, or they cost over $6.00 each

    Any suggestions?
    Tags: None
    • sofTest
      Badcaps Veteran
      • Aug 2008
      • 361
      #2
      Re: Looking for some fans

      You don't specify voltage, but:

      50x10:
      Searching Google, I found among others Fantronic.

      80x15:
      Again Google
      ------------
      Be a mensch

        Comment

        • Maxxarcade
          Badcaps Veteran
          • Jul 2006
          • 973
          #3
          Re: Looking for some fans

          I ended up getting everything from CoolerGuys. Still shocks me how much fans cost these days though. I used to be able to get 50mm Delta fans for .99 each at MCM.

            Comment

            Previous template Next

            Related Topics

            Collapse
            • emil_t
              RTX3090 working fine but fans not spinning
              by emil_t
              Hello guys. I have a problem with a PNY XLR8 GAMING RTX3090 graphics card. The problem is that it displays and works fine, but the fans don't spin at all. The problem occurred when someone else removed the fans in order to clean it and broke one of the fan connectors. He replaced it himself and after that, it wasn't working anymore. I guess he damaged something else in the process. What i have done so far: I found 2 capacitors next to the connector that were in a bad shape, he must have touched them with his tools - they weren't shorted, but i replaced them with similar ones from a similar card....
              04-12-2024, 06:54 AM
            • JayPoorJay
              Hot Water Rad - A Few ECU Fans and a Timer Switch
              by JayPoorJay
              Good Afternoon, Good People.

              I know this will be an elementary little project for most if not all of you, but I thought I would write a post and get put on track, rather than bumbling my way through it with all kinds of trials and errors.

              I REALLY would appreciate y'alls help.

              This is the problem - My wife and I purchased a big ol Victorian/Colonial House in NYC two years ago. The kitchen is surrounded on 3 sides by exterior walls, there is also a 1/4 of the kitchen floor (ceramic tiles) that has a crawl space underneath, and the kitchen gets FREEZING cold...
              10-29-2024, 12:54 PM
            • sda sad
              my Xiaomi Notebook Pro X laptop fans work like crazy for no reason
              by sda sad
              Hope this is the right place, someone can help me.
              My laptop started having a really strange problem....
              When I turn it on the fans start working at a crazy rate and with random breaks...
              They can work for say 10 seconds and stop for 2 seconds and then turn on again for 5 etc...
              And it's from 0 to 100%. I tried to install AIDA and did the processor chip test and the graphics did not exceed 70 degrees and the fans were not even close to working at the power they work randomly.

              The model of the computer:
              Xiaomi Notebook Pro X 15 OLED (A30)

              ...
              04-23-2024, 09:55 AM
            • johnnylotto
              System76 partial power-on, VDD1.05 out fail
              by johnnylotto
              Laptop:
              Hello, I have a System76 Gazelle laptop (model gaze14) which now only partially powers on and does not boot properly.

              History:
              This laptop has served me well for a few years. It's always been a bit noisy with the fans and recently became much more so on both fans, where just opening a vim/notepad session would cause the fans to spin up loudly and make a grating sound, like the ball bearing were mechanically wearing out. So after blowing the dust out of the fans out didn't help, I ordered replacement fans and heat sink component from System76 which were sold...
              09-18-2022, 01:06 AM
            • joesmoe91
              Dell Precision 5530 15" died to blown chip. Replaced chip and now only get momentary fans, lights, no screen or boot
              by joesmoe91
              Hello,

              My Dell Precision 5530 turned off suddenly when I was running Matlab and wouldn't turn on, show any lights, fans, and/or any signs of activity at all. I opened the case, removed the battery and looked at the board with a thermal camera while the AC adapter was connected. I saw that PU1252 was >120C so figured the chip had died on me Got the part number off the attached schematic (see Mouser link below) and replaced the chip. After replacing the chip the board (connected to AC adapter) was able to briefly power on, spin the fans a little bit, and turn on the front led lights....
              02-22-2024, 07:38 PM
            • Loading...
            • No more items.
            Working...