Title says it all, need GS series datasheet, it's not in the depot.
-
Popcorn. -
Re: Evercon GS Datasheet Needed
I'm looking for them tooCap Datasheet Depot: http://www.paullinebarger.net/DS/
^If you have datasheets not listed PM me -
Re: Evercon GS Datasheet Needed
Currently looking deep to try and find them, found some other cap makers on the way, one is labeled "Tanyu", however they seem defunct and then I found a more common one branded, "R.M" they have another logo that is newer and more graphic, same letters though, will post all newer datasheets to the depot.
Another one is Kingtronics, caps will be branded "K T" in a fancy font. Lotta datasheets incoming.Popcorn.Comment
-
Hello,
does anyone know where to find datasheet for it8225vg chip? I can't find it on their official website. -
Hello,
My Dyson Pure Hot+Cool, model HP00, no longer starts.
After disassembling and accessing the electronic motherboard, I found that the 16A fuse soldered to the motherboard is dead. I decided to do an electronic shunt to see the reaction, and the Dyson turns on for a few seconds and then turns off.
It is likely that a voltage control chip or a safety chip is dead, but without the electrical schematics, the repair becomes complicated…
Thank you in advance for your help.
Best regards
-
First post -Intel NUC 10i5 -BXNUC10i5FNH not powering on -IC burnt- request for IC details/datasheetHi all,
I came across this very active forum with knowledgeable folks on electronic circuits and components, while google searching for the details of my burnt IC marked 7603 in Intel NUC board. I joined this forum today and this is my first post here.
I recently got an Intel NUC 10i5 and had installed Linux Mint and was using it for about a month when it died suddenly and did not power up after that.(Power Adaptor is ok). When I opened the NUC , there was a burnt IC marked 7603 (and ILCB in second line). I am unable to find the details/datasheet of this IC. I will be grateful if... -
Hi, pulled this component, (I'm assuming it's a MosFET) from an LED COB video light. Im trying to find the datasheet so I can find an equivalent replacement but no luck. Any assistance with the datasheet would be appreciated.
Failing that, a way to pick a suitable replacement component? If it's indeed a switching fet, I'm assuming I might need to measure the switching clock frequency and find a component that meets the power capacity?
Its a pair of them driving a 130w Light. Takes in 19volts. I can borrow a scope to measure the switching freq.... -
I got a dead HD6950 on Ebay to try my luck and repair it. There were a few broken off capacitors that I already replaced.
Measuring the PCI-E lanes I got somewhat weird measurements, the gpu might or might not be dead.
If I plug the GPU in, the core heats up and I also get VCore but on two inductors that measure 16 and 60 Ohms respectively (Memory and PEX I guess) there is no voltage.
On one of the two buck-controllers (APW7165) the enable pin is pulled to GND and the other controller I just cannot find a datasheet for.
So if anyone has a datasheet or at least...
Comment