http://img.photobucket.com/albums/v3...052_edited.jpg
because I need to know type of cap and values of same.
because I need to know type of cap and values of same.
-
-
Re: Please Help ID This Cap
they are oscon svp 1200uf 4v.
Last edited by willawake; 04-23-2006, 03:18 PM.
-
Dear reader
I am performing a repair on a Sony ICF-SW55, which includes recapping (some) of the SMD capacitors on the mainboard. I am looking for verification of their values. At the moment, I'm 95% sure I've got the right values, but it is hard to find some official, credible or multiple independant sources on this.
At the moment, I have selected replacements based on the following list of values:
3 x 470uF 10VDC
3 x 4.7uF 35VDC
4 x 47uF 50VDC
8 x 22uF 6.3 VDC
1 x 220uF 6.3VDC
5 x 100uF 6.3VDC
Which... -
Dear Alls,
For sure it id a stupid question, but help me to understand. I am in a Dell 2007WFP revitalizing project - searching reason why not starting. Some resistors needed to replaced is is obvious. When I have soldered some resistors the measured (with multimeter) values were sometimes rather different written on them. I supposed these are wrong units so I desoldered and made a checking measurement and voilá the values is the same is written on. This happens only in case of a few resistors, most have the same values (+/- 10%) are written on it. "strange" SMD resistors =>103... -
Here some measurements on HP Victus 16-d0500la, it might help someone, the values are on diode mode->mV and some lower ones on Resistance->Ω.
This specific laptop has an Intel i5 11400h + RTX 3050TI, the values are from a working laptop....03-13-2025, 03:16 AM -
mb GA-X5L
Good day to all, I need help with the values of the knocked down resistors.04-02-2025, 06:15 AM -
Trying to fix this board, MSI K7T Pro2.
All Tayeh capacitors showed either as damaged or with uf values which were faf from what they should be so I have replaced them and all other capacitors except those big ones near CPU.
The motherboard powers on but doesn't post. My PCI bios code reader will most of the time dsplay some some kind of code if there has been no power to board for a while but I don't think those codes mean anything in this situation. If I power off the board and try powering it on the second time the code reader usually doesn't show anythin. Unplug...
Comment