Guys, I have a I-INC tw191d Monitor that someone gave to me because it had problems - dim display, won't come out of standby, etc - getting worse. I took it apart and found 5 leaking caps - 3 470uf 25V, and 2 1000uf 10V. I replaced those, and the monitor powers up, shows the test "No Signal" message. Looks good, so I reassembled and tested on a computer - no image from the computer. I tested with another cable - fails.
So the monitor works as far as displaying the test "No Signal" message, but won't display any computer image.
Could one of the caps I replaced caused this issue? I'm well versed in soldering, so I can't believe I damaged anything else on the board, but I suppose anything is possible - but nothing that looks obvious visually.
One thing I should mention - the 470uf Caps are a little shorter than the original - 12mm instead of I think 14 or 15mm, but that shouldn't matter. Other than that, I have no idea what happend.
Can anyone help?
So the monitor works as far as displaying the test "No Signal" message, but won't display any computer image.
Could one of the caps I replaced caused this issue? I'm well versed in soldering, so I can't believe I damaged anything else on the board, but I suppose anything is possible - but nothing that looks obvious visually.
One thing I should mention - the 470uf Caps are a little shorter than the original - 12mm instead of I think 14 or 15mm, but that shouldn't matter. Other than that, I have no idea what happend.
Can anyone help?
Comment