This Magnavox TV doesn't power on at all. It was very obvious why right when I opened it, the fuse is blown. And it looks like an extremely low quality power board. I'm guessing there are some shorted diodes somewhere and that the fuse would just blow again if replaced. The customer wants the TV back ASAP, so I was just going to do a board swap and replace the 85C caps.
The stock board is a BA17F8F0102 2 and the one I'm looking at online is a BA17F1F0102 5. It looks to be the same type of board with a smaller caps and a nichicon primary instead of HEC... Should it work correctly?
The stock board is a BA17F8F0102 2 and the one I'm looking at online is a BA17F1F0102 5. It looks to be the same type of board with a smaller caps and a nichicon primary instead of HEC... Should it work correctly?
Comment