Добрый день меня зовут Фирдавс из Республики Таджикистан я занимаюсь ремонтом компютеров, ноутбуков, принтеров и на этом форуме Я хочу участвовать для своей технической работы.
New Members - please post your introductions here
Collapse
This is a sticky topic.
X
X
-
-
-
-
I've been in the electronics distribution side of the business since 1990. I'm not an engineer but I understand the basics. I'll probably be here to ask for support as needed, hoping someone has old information that I can't find online. I may also, time provided, start looking to repair some old items I have in storage.Comment
-
Hi every one. I'm Etonam from West Africa, Benin Republic (on the left of Nigeria). I like Electronics, Computers, fixing things electronic. I'd like to become part of BadCaps community and learn/receive help from the knowledgeable people in here and hopefully get to helping others. Thanks for letting me in. EtonamComment
-
-
Tôi là người đam mê sửa chửa và học hỏi phần cứng laptop, trên này tôi đã học đc rất nhiều , cám ơnComment
-
Hi together,
I am Marvin from Repair. What else? in Northern Germany - I am a stately approved electronical engineer and I am into repairing all kinds of electronics over 10 years already.
My main repairs are based on consumer electronics, but sometimes also car, industrial electronics are on my desk.
I want to save as much devices as possible and therefore try to check everything possible on the devices. Most of the income is reinvested in new equipment to improve the analytical ability on my side.Last edited by Repair.Whatelse?; 12-01-2023, 03:22 AM.Comment
-
From a lot of searching around for solutions to a particular problem Im currenly having I kept seeing badcaps urls. So figured I'd sign up and see what I can learn from everyone here.
Bit of a warning though, I will most likely be leeching knowledge with very little of my own to give back hahahahComment
Related Topics
Collapse
-
by fredyjbiplease help friends thinkpad T470 board CT470 series NM-A931 error post "bottom cover tamper detection error"
I've already
flashed the bios clean me and updated from the Lenovo site, then removed the switch and immediately jumped the S3 from pins 1 to 4, 2 to 3 but the problem remained the same, thank you1 Photo -
by fredyjbiplease help friends, I have 3 T490 units with the same case, the USB type C is completely dead, showing 20v 0 amp, loss of voltage VINT20_IN resistance to ground is fine, thank you
I think the problem is that I lost the voltage at PQ0008 pon 1 -PWRSHUTDOWN which should have been high which was picked up by R9512 VCC3SW, thank you very much for your help
PF0002 20v
PQ0005
pin 5 20v
pin 1.2.3 19.8v
pin 4 19.8
resistance
source & drain 2,4 m
source & gate 100k
PQ0006
pin 1.2.3 19.8v
pin 4 19.8v... -
by fredyjbiplease help friends x1 yoga 7th no display beep melody thank you...
-
Channel: BIOS Requests ONLY!
-
-
by fredyjbiplease help friends clean me bios x1 yoga 7th no display melody beep, thank you
-
Channel: BIOS Requests ONLY!
-
-
by fredyjbiPlease help friends, thinkpad t480 nm-b501 is dead, help me fix it, thank you
usb meter 20v 0.00 amp, after I took the VSYS measurement the drop was only `9.2v which should have been 10.2v I measured from a normal matherboard machine, the VSYS path resistance to ground diode mode is 1900 thank you
LINK to Schematic -> https://www.badcaps.net/forum/troubl...b501-schematic - Loading...
- No more items.
Comment