UN SALUDO A TODOS .. LES SALUDA JUAN UN TECNICO QUE TRATA DE SALIR ADELANTE CON GANAS DE APRENDER Y TMB APORTAR CON LA POCA EXPERIENCIA QUE TENGO.. ESPERO PODER CRECER JUNTO A TODOS LOS MIEMBROS ASI COMO VEO QUE ESTE FORO CRECE CADA DIA
I need help, I bought a HP Probook 4545s on ebay. Everything was good until I had a power outage and now my laptop has an error code (00A). My serial number is wiped and there is a user id and password that I don't know to access the bios. What do I do?
Hi, I am a guy who is trying to repair his own X555LD rev 3 board. Power pins are good. No video, only 0.50A pulled from 19V supply. Removed ram chips, disabled onboard ram due to one ram chip heating to 100deg on startup. Now still no video.
I would greatly appreciate any assistance with my response code,
as I cannot afford to pay for help;
I've been informed that someone named "evserv" on this website might be able to assist me.
Hola, señores.
Trabajo con equipos electrónicos de automoción, últimamente me estoy peleando con alguna tablet rugosa Panasonic así que encantado de aprender por aquí.
Gracias de antemano.
Saludos
Hi everyone! My name is Antonio, I’m passionate about technology and I’ve been tinkering with PCs and consoles since I was 14. I love learning, experimenting, and solving hardware and software issues.
please help friends thinkpad T470 board CT470 series NM-A931 error post "bottom cover tamper detection error"
I've already
flashed the bios clean me and updated from the Lenovo site, then removed the switch and immediately jumped the S3 from pins 1 to 4, 2 to 3 but the problem remained the same, thank you
please help friends, I have 3 T490 units with the same case, the USB type C is completely dead, showing 20v 0 amp, loss of voltage VINT20_IN resistance to ground is fine, thank you
I think the problem is that I lost the voltage at PQ0008 pon 1 -PWRSHUTDOWN which should have been high which was picked up by R9512 VCC3SW, thank you very much for your help
Please help friends, thinkpad t480 nm-b501 is dead, help me fix it, thank you
usb meter 20v 0.00 amp, after I took the VSYS measurement the drop was only `9.2v which should have been 10.2v I measured from a normal matherboard machine, the VSYS path resistance to ground diode mode is 1900 thank you
Comment