Hi there. I have this tv and what happened is at follows.
I had the rebooting problem with it and solved it by ordering the nand and replacing it. Atfer that it had no hdmi imput from any of them 1 through 4. Entered service mode factory reset same thing.
In the end i entered service mode again and i had changed some setting (dont remember wich one) and the tv froze. Unplugged it and after plugging it back in if has no stand by light at all and is completly dead.
Opened it up and found out that the processor heats up farly high (not sure if thats normal or not)
The thing is that i dont know if i killed it by changing that setting or if it was just pure coincidence and the processor just died out.
if i disconnect the main board i get backlight on the tv.
My guess is that even if that setting changed it in any way it can't really make it that is dead dead. Can it?
Dont ask me what setting i changed because i have no idea.
Where is that service mode stored? In NAND or in some other part
I had the rebooting problem with it and solved it by ordering the nand and replacing it. Atfer that it had no hdmi imput from any of them 1 through 4. Entered service mode factory reset same thing.
In the end i entered service mode again and i had changed some setting (dont remember wich one) and the tv froze. Unplugged it and after plugging it back in if has no stand by light at all and is completly dead.
Opened it up and found out that the processor heats up farly high (not sure if thats normal or not)
The thing is that i dont know if i killed it by changing that setting or if it was just pure coincidence and the processor just died out.
if i disconnect the main board i get backlight on the tv.
My guess is that even if that setting changed it in any way it can't really make it that is dead dead. Can it?
Dont ask me what setting i changed because i have no idea.
Where is that service mode stored? In NAND or in some other part
Comment