How to flip image on vestel tv?

[Rman86]

Hi all, I've done lots of searching regarding this but I'm only seeing incomplete information.

Basically I have swapped the panel from a non smart 32 Bush VES315WNDA 2D N04 into a smart BUSH TV with originally a VES315WNDA 2D N12.

This results in a flipped image.

How can I correct this?

Is it a case of downloading the 2D N04 profile from the original tv and uploading to my donor via USB. My original mainboard is an MB82s, new mainboard is an MB130.

Help?

[dick_barton]

Re: How to flip image on vestel tv?

Have you searched through the "Service Menu" to see if the option is available.
Posible codes to enter service menu
https://factory-reset.com/wiki/Bush_Service_Menu

[yokoono]

Re: How to flip image on vestel tv?

I do not understand. Now on TV you have 17mb130 and what panel ?. Vestel cannot return the image from manual service. It can be done with a panel profile copied to a stick.

[Rman86]

Re: How to flip image on vestel tv?

Sorry i was kind of rushing earlier due to low device battery.


I have a smashed 32" bush smart vestel with a VES315WNDA 2D N12 PANEL.

After I fitted a panel with same physical connections etc, from a non smart bush tv with VES315WNDA 2D N04 printed on the chassis sticker, the image has flipped vertically.
I'm trying to correct this.

My good panel (2D N04) came from a tv with an MB82S board (
The patient tv has a MB110P (corrected from first post)

So the current configuration I have is, a N04 Panel in a N12 shell with its original mb110p and N12 PANEL profile

I've tried the easy route of finding a compatible board on eBay and switching over brand. But there doesn't seem to be any smart models using this panel number available.

I mentioned the board models because I'mnot very familiar with the files that need extracting and reloading. Or it's process.

[ducky29]

Re: How to flip image on vestel tv?

Use a vestel profile on a stick ( new board + non smart screen )