LG 50PS3000 noisy picture

Collapse
X
Collapse
 
  • Page of 2
  • Time
  • Show
Clear All
new posts
Previous 1 2 template Next
  • bbjunkie
    Badcaps Veteran
    • Dec 2011
    • 301
    #21
    Re: LG 50PS3000 noisy picture

    Replacement Y sus board arrived today, the problem is gone. However the board is faulty as now I have no top half to the picture with some horizontal lines

    Bottom half is absolutely perfect. Tried re-seating the ribbon cable which made no difference. Top half of picture works with other board, both are same part number & revision.

    Getting there! Raised a dispute with eBay seller

    Jim

      Comment

      • bbjunkie
        Badcaps Veteran
        • Dec 2011
        • 301
        #22
        Re: LG 50PS3000 noisy picture

        Replacement Y board came today, fitted and all faults gone.

        Another one saved from landfill!

        Thanks

        Jim

          Comment

          • tvtimmy
            Badcaps Legend
            • Mar 2015
            • 1160
            • usa
            #23
            Re: LG 50PS3000 noisy picture

            Good job!

              Comment

              Previous 1 2 template Next

              Related Topics

              Collapse
              • Tr0ll
                T-con suspect issue. Both ribbon cables no picture. One ribbon cable ok. (58pus8545)
                by Tr0ll
                Hi guys! I realized you have a lot of knowledge here so i am hoping you could point me in right direction with my odd issue.

                The Tv is a Philips 58PUS8545/12, it had no picture but working backlights.

                Original T-con:
                Opened the Tv and tested to unplug one ribbon cable at a time. With this test i could see that i got fine picture on both halves as long as there was only one ribbon cable connected, with two connected picture were gone.

                First replacement T-con:

                I thought it might be t-con and ordered new t-con from china(supposedly tested)...
                10-07-2023, 07:48 PM
              • JJAAMM
                SAMSUNG UN55KS9000F picture fades then distorts into vertical lines after 20 seconds
                by JJAAMM
                This was my main TV for the last 6 years. I'm not inclined to throw out a $2600 TV so quickly so I'm trying to investigate the issue.

                Problem
                TV was disconnected from power for 6 months during construction. When I plugged it yesterday picture was fine, after 30 seconds it dimmed then started developing horizontal lines, picture then starts to ghost vertically until it degrades into vertical streaks. TV always displays a perfect picture when cold. I can unplug TV for 5 minutes and plug it back in and picture is restored for 20 seconds. I can also keep it in standby mode...
                07-06-2023, 06:01 AM
              • TR103
                Samsung TV model UE50TU: rebooting, backlight, sound, but no picture
                by TR103
                Hi, I have a Samsung UE50TU with:
                - sound and backlight, but no picture
                - when it arrived, it had a picture for a few seconds
                - it keeps rebooting
                - without ribbon cable between the two panel boards, it does not reboot but I have no picture
                - without cable between mainboard and lcd panel, it does not reboot (but obviously i have no picture)
                - when i try a tape fix, its keeps rebooting, unless I tape off pin 1 (the innermost pin). In that case it does not reboot but I have no picture.

                - without cable between mainboard and lcd panel and with a jumpered...
                01-22-2025, 04:12 PM
              • Jne2016
                toshiba tf-43a810u21 flickers/shakes but with good picture
                by Jne2016
                Anyone have any experience with these tvs I just got this tv off marketplace and the screen will flicker/ shake for a couple seconds than stop then repeat.


                I tried fact reset but it can't get past searching for remote even though I have 2 remotes that work for it. Now initially the screen wasn't shaking at all after factory reset intill it got to searching for remote and it was taking for ever so I turned it off and back on and it started to do it again.



                Is this a hardware issue or a board?...
                10-13-2024, 09:01 AM
              • Mgiffune
                Samsung UN60EH6000F Black Screen, Backlight and Sound Good. Power Cycle Returns Picture
                by Mgiffune
                I have a 60 inch Samsung UN60EH6000F flatscreen TV. The screen went black a few months ago Sound is good, backlight is good, no menu. I replaced the TCon board with a used board purchased from Ebay. It worked fine for a 3-4 months, then the screen started ‘fading' back. Once again, sound is good, backlight is good, no menu. However, this time the picture looks fine for about 10-15 minutes, then fades back. If I power cycle the TV, the display reappears, for another 10-15 minutes, then fades black again. Repeatable ever time.

                I ordered a supposedly ‘new' Tcon board this time, and                ...
                06-09-2024, 10:28 AM
              • Loading...
              • No more items.
              Working...