HG46NC890XFXZA vertical lines

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • TRPara
    New Member
    • Oct 2020
    • 2
    • United States

    #1

    HG46NC890XFXZA vertical lines

    I was hoping to fix this tv as I have a large 3d movie collection.
    I have replaced the T-con board with no difference.
    I was hoping it was not going to be a bad panel.
    Pic is a close-up left side of screen.
    Attached Files
    Last edited by TRPara; 10-09-2020, 03:12 PM.

Related Topics

Collapse

  • Stanley1843
    Screen Display Vertical Multicolor Lines
    by Stanley1843
    Hello, I have a screen in where sometimes when I open it pop-up vertical multicolor lines (I would say the most of them are green). If I tun off and turn on the screen the lines dissapear or if I leave open the screen after approximately five minutes the lines gone. I measured the below voltages on the main PCB and on the T-CON board and the voltages are the same when it doesn’t display the vertical lines and when it displays the vertical lines. Also, I cleaned all the connectors very good with IPA. I moved back and forth the connectors and the COF tabs but the vertical lines didn't displayed...
    06-29-2024, 11:54 AM
  • gpo23
    Sony KDL-40V3000 - Vertical lines
    by gpo23
    Hello,

    i order a t-con because i had bad colors on my SONY KDL-40V3000 :




    With the new t-con the color are good but there are vertical lines on all the screen :




    I've tried the old t-con and it returned to the initial issue (bad colors but no vertical lines)

    Is there a way to fix the vertical lines on the new t-con ?

    Thank you for your help

    gpo23...
    10-04-2023, 09:11 AM
  • Firentiosi
    1/3rd of screen black with occasional vertical lines - repair attempt for learning! - Kogan KALED58RT9220SVA
    by Firentiosi
    Thanks for offering your assistance with this. I'm an electronics enthusiast with moderate level of competence (have a decent lab with two power supplies, microscope, DSO, hot air, good iron, can competently work at a component level on SMDs, design and solder own PCBs etc). I really enjoying fixing things and learning new stuff so took up a free 58" LED TV and have been googling and watching Youtube videos to see if I can fix this! I am happy to go down to individual component replacement/strip replacement etc - it's all in the name of learning.

    The issues are as follows: the...
    11-27-2024, 12:33 AM
  • viking509
    vizio e65 e3 LED tv color vertical lines center tv only
    by viking509
    I recently replaced the led backlights with LB65041 LED Backlight Strips and after putting it back together the backlights work but there are only colored vertical lines only in the center of the tv. I can see the Netflix logo (jumbled) after a minute or less the screen went dark. When I turned it on again the lines were back. Then I replaced the t-con board but the same vertical lines in the picture. My question is what is my next step? Could it be a source tab bond issue? A buffer board issue? Could I have loosened a connection to the panel when replacing the backlights? Should I replace the...
    03-21-2023, 12:48 AM
  • rfxcasey
    Vertical Lines on Half of LCD Display
    by rfxcasey
    I have an Siemens HMI with vertical lines on half of the screen. These lines aren't scrambled garbage but rather very regular in pattern and color. I have replaced the LCD with a new one and still the problem persists. I'm wondering if this isn't indicative of a bad video process chip or video memory? Any help would be appreciated. The cable appears to be OK but one pin on the header is unpopulated, though there isn't any loose wire to suggest one broke off or popped out of the connector. In the picture below where the connector is busted out of the side, I did that with my small screw driver...
    05-16-2024, 06:52 AM
  • Loading...
  • No more items.
Working...