Scrap board with intact primary required please. Will pay costs etc. Call steve 0786792512.
Kind Regards
Steve
Kind Regards
Steve
-
Casper c510 mother board code 08N1-18Y4Y00 Rev 2.2 KBC required Can someone please share? -
Hi,
I need to replace the LEDs of this TV. The screen is glued with double sided tape. This video shows the proceudre required.
I need a source for this type of double sided tape adhesive please.
https://www.youtube.com/watch?v=bN6g...nel=QUADRA-NET
Tks! -
Hi All,
Need a bit of assistance digging up some information on current technology support required for modern motherboards to post? By modern let's say 6th gen skylake to current intel and all of the Ryzen series. You would think this would be on the ARK product page, but nope. Besides saying dedicated graphics required it doesn't really tell you squat.
Reason I ask is I've ran into this a few times now (first on 6th gen SkyLake and now on 12th gen AlderLake) where if I use an intel F SKU CPU multiple different boards refuse to post with multiple different graphics... -
HikVision DS-7104HQHI-K1 Motherboard: DS-80303_P REV 2.0 and SN: C47579229 Firmware dump or unlock required. Thank you!...06-11-2025, 01:54 PM -
Hi all,
First time trying to fix a TV for a friend, it's a Bush DLED32165HD.
Power Board - 17IPS11
Mainboard - 17MBS82S
Panel - VES315WNDB-02
Red blinking standby light is on steady, press power button on remote and light flashes 7 times then stays steady, press power on remote again light flashes 10 times and then goes off.
Checked all the voltages on the power board inc backlight circuit, they all read ok and are stable. Backlights tested with backlight tester and all work fine (2 strips x11LED on each).
No picture, backlight or sound just blinking...