Lg 55lm6410

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • wazzadj@hotmail.com
    Wazza
    • Nov 2017
    • 57
    • Australia

    #1

    Lg 55lm6410

    Hi
    i have a problem with the display showing a rey bar down the left hand side of the panel
    please refer to attached pictures
    I have replaced the main power supply board because the unit would not turn on when i received it , i have checked all the cables are seated properly and aligned , i have checked all the supply rails to the main board ect.... all ok
    i have tried all inputs the fault is reflective on all inputs
    so i believe that the MAIN BOARD is at fault
    So before i go purchase a Board has anyone seen this fault before ?
    is the MAIN BOARD the fault here, or could it be the panel?

    your help is appreciated

    cheers
    waz
    Attached Files
  • yohnsee
    Semi-noob
    • Dec 2017
    • 198
    • Hungary

    #2
    Re: Lg 55lm6410

    Hello,
    from the mainboard runs 2 white ribbon cables (on your picture downways). Are they connected directly to your LCD panel, or is there an other little PCB? If so, that is your T-con panel. That can cause such abnormalities on the picture.
    First test you can do: IF you have a T-con panel and IF the cables can be disconnected from it (not the white ones, those that run to the LCD panel), than disconnect one side of it, then turn your set on, show us what picture does it show. Then switch off your TV and do the test with the other side connected.
    Cheers, Janos

    Comment

    • Andrew F. Ali
      Badcaps Legend
      • Jan 2014
      • 2450
      • Trinidad & Tobago

      #3
      Re: Lg 55lm6410

      It appears as though only half the screen is showing. Recheck both sided of the FFC seating and position, leaving the Main Bd. and going to the T-CON Bd on the affected side.

      Comment

      Related Topics

      Collapse

      • Dani_2024
        Sceptre U550CV-UMR 4K LED, Bad Caps on Main Power Board?
        by Dani_2024
        Hi and thanks in advance for any input you might provide!
        I have a Sceptre U550CV-UMRD8POTV83BB 4K LED (this is a dumb tv) that I bought new in August 2021, so It's just completed 3 years.
        Main power board model: TP.MS3683.PC821 T-Con board: N4TP546UHDPU2L_BO

        Last Sunday I was watching a dvd and fell asleep for about half hour, when I awoke the tv screen was black and couldn't get the dvd menu to show, so I changed the input to antenna and had sound but no picture, turned it off. I then got online and found this great site! ....read many troubleshooting tips and this...
        10-28-2024, 05:06 PM
      • ygorsan
        LG 55NANO77SRA TV – Menu scrolling by itself even after removing button board (Main Board EBU66792103)
        by ygorsan
        Hi everyone,




        I’m looking for help with a persistent issue on an LG TV model 55NANO77SRA, which uses the main board EBU66792103 (also used in LG UQ80 and NANO75/NANO80 series).







        🧩 Problem Summary:
        • The TV keeps scrolling through the menu or selecting items by itself.
        • I removed the physical button board (the entire panel with power and volume buttons) and also disconnected the flat cable (CN202) from the main board.
        • The remote control is not in use (batteries removed), and the TV still shows the same behavior.
        • I
        ...
        07-28-2025, 08:34 AM
      • JDC
        (SOLVED) - ONN 100012588 No Power, Then Rebooting After Main Board Change
        by JDC
        ONN 100012588
        Issue: No Power, Then Rebooting After Main Board Change

        Short answer: replace main board and power board
        Technical answer: replace main board and Q306 & Q307 on power board.

        Long answer:

        TV wouldn't turn on. Power switch was fine which means the main board isn't processing the power on signal. Replaced main board. TV turns on now but randomly reboots. Bad main board? EEPROM? Tried to pull main board and got a shock touching the corner of the board. That's weird. C334 (450V 10uf) capacitor is still holding a high charge....
        07-15-2022, 07:39 AM
      • cheeky2
        Is it possible to upgrade from a Vestel 17MB97 main board to a 17MB110 Main board?
        by cheeky2
        I suppose the real question is whether the existing pinouts from ether a 17IPS71 psu are cross compatible with a 17IPS12 psu? If they are then the exchange of the main boards should have no issues providing the screen is compatible with both main boards. Obviously you can change the screen configurations easily enough (providing you have the correct files) for the main board. Why may you ask would I do this? Well a lot of the smart features are no longer working on a Hitachi 48HBT62U main board I wish to give it a new lease of life!
        Obviously the same LVDS connector for the screen connection...
        05-25-2024, 03:27 AM
      • Asraf Atb
        Help Needed: Samsung UE55MU8000 Dead - Possible Main Board Issue
        by Asraf Atb
        Hi everyone,

        Im looking for some advice regarding my Samsung UE55MU8000 TV with main board model BN94-11606C. The TV suddenly stopped turning on and now shows no signs of life at all not even the standby light at the bottom.

        Initially, I suspected an issue with the PSU, so I took it to a repair center. They tested it and confirmed that the PSU works perfectly, even on other TVs. Based on that, I started investigating the main board.

        I disconnected the main board from the PSU, and the backlight turned on, which seems to confirm the main board is the issue....
        01-27-2025, 05:02 PM
      • Loading...
      • No more items.
      Working...