Fox 32DLE250 startup loop

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • Morsus
    Senior Member
    • Nov 2016
    • 96
    • Serbia
    #1

    Fox 32DLE250 startup loop

    Hello folks, I layed my hands on FOX 32DLE250 TV which is stuck in startup loop. I opened it up thinking its an board problem. I have checked every cap and transistor there is and it all turned up to be absolutely fine nor there are any damage marks.
    I googled this problem and found that it could be a firmware fault. I've found that there is a full reset pin on TV boards but I can't seem to find it on this one. Also I tried to reinstall/repair firmware with USB stick but nothing new happened. Anyone had a similar TV problem?
    Attached Files
    Tags: None
    • dskall
      Badcaps Legend
      • Oct 2016
      • 2905
      • usa
      #2
      Re: Fox 32DLE250 startup loop

      Is it stuck on your first picture or does screen go off like your second picture?
      I assume no responsibility for any stupid suggestions I might post.

        Comment

        • Morsus
          Senior Member
          • Nov 2016
          • 96
          • Serbia
          #3
          Re: Fox 32DLE250 startup loop

          Sorry about not explaining better. So when I plug it in it shows the FOX logo for like 5 sec and after that screen goes black and red led diode lights up for also a few seconds. This process repeats.

            Comment

            • dskall
              Badcaps Legend
              • Oct 2016
              • 2905
              • usa
              #4
              Re: Fox 32DLE250 startup loop

              Seems to be eeproms for various models of this board. Try freezing eeprom and see if it will start up.
              Last edited by dskall; 06-17-2017, 06:54 PM.
              I assume no responsibility for any stupid suggestions I might post.

                Comment

                • Morsus
                  Senior Member
                  • Nov 2016
                  • 96
                  • Serbia
                  #5
                  Re: Fox 32DLE250 startup loop

                  Sorry I have never encountered a problem like this (with eeprom) can you explain how to freeze eeprom?
                  Thank you.

                    Comment

                    • tvtimmy
                      Badcaps Legend
                      • Mar 2015
                      • 1160
                      • usa
                      #6
                      Re: Fox 32DLE250 startup loop

                      Take a can of computer keyboard duster(compressed air) and hold it upside down.
                      Spray the part. It will start as a liquid then freeze on contact.

                        Comment

                        Previous template Next

                        Related Topics

                        Collapse
                        • Faluky
                          firmware for Marantz SR5008 stuck in update loop
                          by Faluky
                          After an update it stopped playing audio and video, I have reset it as it says in the manual and tried to reinstall the firmware over the internet but logging failed each time and I tried to download the firmware to install it by usb but it does not appear on the official page, could you help me? Since it would be a shame to have to get rid of him, European version Thank you very much
                          Best regards.

                          Anyone got their hands on firmware for Marantz SR5008 stuck in update loop
                          01-17-2023, 04:33 AM
                        • BMCappelletti
                          Lenovo Thinkpad E14 Gen3 stuck on "To interrupt normal startup, press Enter" screen
                          by BMCappelletti
                          Hi everyone.
                          Lenovo Thinkpad E14 Gen 3, stuck on the "To interrupt normal startup, press Enter" screen.
                          Found a lot of people with this issue, but with no definitive answer. Some people managed to get away accessing BIOS, going to Startup and turning off "Option Key Display". For me that only removed the interrupt normal start up message, leaving only the Lenovo logo.
                          Most people say hitting Enter does not work. It's true, if you wait a few seconds. But if you hit Enter right away you get the options to enter BIOS (which works), run diagnostics (goes to a...
                          02-18-2025, 12:22 PM
                        • FlashFireSix
                          LG xboom PN5 stuck in demo mode(?). Looking for retail firmware.
                          by FlashFireSix
                          I took an ebay gamble on an LG xboom pn5 speaker which was listed as having battery issues (turning on then off).

                          I got it earlier today and concluded it's in a demo mode because of the following:
                          • When it's plugged in, it'll turn on and the power button will not turn it off
                          • Battery is healthy, reading 4.2v and not swollen, charges according to the xboom app
                          • the play/pause and volume buttons don't work
                          • You can pair to it and play music fine, as long as it's connected to power
                          • The bluetooth connection is disconnected after 5 seconds of audio pausing
                          • The DTS setting is defaulted
                          ...
                          06-26-2024, 09:35 AM
                        • Mschrenkz@gmail.com
                          Hisense 60R6E - No backlight - stuck in boot loop
                          by Mschrenkz@gmail.com
                          I joined hoping I'll be able to verify which component I need to replace on my Hisense 60R6E. When I plug it in the red light comes on and stays on for several seconds then blinks off and then on again. There is no back light but I can see the logo screen "Hisense Roku" (using the flashlight method) come on while the red light is off. Then it dissapears and the red light is constant again. This cycle keeps repeating. I tried pressing the reset button and it has absolutely no impact. Even held it in for 30 seconds also tried holding the power button in with the TV unplugged - nothing...
                          05-09-2023, 08:53 AM
                        • TheUser
                          Thinkpad Docker G2 Type-C 40AS - Firmware Unknown
                          by TheUser
                          Hello to everyone ,

                          This is my first post here, and i would like to share with you a small story in case you can help me.

                          Docker Type-C Gen 2 - Model 40AS. Was given to me by a friend for free ,but with the problem that you cannot use the video output ports.

                          All ports work , USB , Ethernet, Type C ... but HDMI + Display Port don't work

                          I searched on reddit and google for problem similar to that, and a LOT of people had fixed this problem by updating the firmware. So i tried , i searched and found 1.1.13 utility and 1.1.20 utility that can help...
                          02-10-2024, 02:07 PM
                        • Loading...
                        • No more items.
                        Working...