Question about the Tconn board and ribbon

[Ian54321]

Hi Guys
Tomorrow I am going to attamept the "cut off" method by taping the section of ribbon connected to the Tconn board to cut the power/signal that's causing the panel to short out in that area.

Can I do this with the power turnd on? IS it safe to be plugging and unplugging and adjusting the scotch tape with the power on watching the screen or should I have the power completely off each time I unplug and plug the ribbon to the Tconn.

Thanks for any help I get
IAN

[dick_barton]

Re: Question about the Tconn board and ribbon

Power OFF is the safest method.