sharp 50-lb371u leds problems

Collapse
X
Collapse
 
  • Page of 3
  • Time
  • Show
Clear All
new posts
Previous 1 2 3 template Next
  • robert phelps
    Senior Member
    • Dec 2016
    • 94
    • usa
    #41
    Re: sharp 50-lb371u leds problems

    sorry its been awhile, what could be going on here, can the logic board be keeping the ps on after you turn the set off. thats what im thinking is happening, after powering on can the processor get struck and not turn off the ps like it should

      Comment

      • robert phelps
        Senior Member
        • Dec 2016
        • 94
        • usa
        #42
        Re: sharp 50-lb371u leds problems

        could the psu be getting struck on once it is powered on by the logic board. but not struck when you first plug the set in?

          Comment

          Previous 1 2 3 template Next

          Related Topics

          Collapse
          • Pipolups
            Corsair K70 LUX RGB dying LEDs
            by Pipolups
            Hi there !

            I'm having an issue for several weeks with my quite old K70 LUX RGB keyboard. I haven't used it for few months, and once I setup up again my desktop computer, I got several dead LEDs on that keyboard. I tried the Corsair troubleshooting thing (disabling options in iCUE, ...) but nothing changed so I conclude that for some reason some LEDs went in retirement...πŸ˜…
            Decision taken to change these LEDs as I have access to desoldering iron and binocular magnifier, I wrote a ticket to tech support, hopping to obtain the LEDs reference and... They refused to tell me πŸ™„...
            10-08-2024, 11:58 AM
          • JayPoorJay
            Sharp 70' LEDs Spike 260v at start up?
            by JayPoorJay
            Hi all. This is my second thread. Have a bunch of questions.

            I got my hands on a 70 inch Sharp Aquos LC70EQ10U. Not working when I found it.

            I replaced the power board (found in eBay) and the TV finally produced an image. Reset it had image and sound.. Went from 2 slow and 2 fast blinks as a fault code to 1 slow 1 fast fault. Lamps or inverters according to the manual. TV is one now, at this moment (looks great w/ ZERO dark spots on screen) but it powering up and producing an image is unpredictable. 3 out of 10 times.

            There are 3 leads to the LEDs....
            02-01-2022, 05:04 PM
          • jean luc ferre
            laptop hp g72 b52sf screen problems
            by jean luc ferre
            Hello,
            on this laptop hp g72 b52sf i have screen problems as you can see with the photo joined in attachments.
            the used graphic card is "intel hd graphics" and the id of the integrated screen is : "monitor/SEC3354".
            i verified the driver of the pΓ©ripherals and they are ok. i verified the definition and settings of the graphic card and of the screen : definition 1600x900 and refreshment frequency :60hz. (they are the sames for the graphic card and the screen).
            i don't understand the reasons of the white stripe at the bottom of the screen below the task...
            06-07-2025, 03:27 PM
          • Easky15
            Sharp LC-39LD145K No Power to LEDs
            by Easky15
            Hi all, Been a while since ive had to use this forum,
            I have here a Sharp LC-39LD145K that works fine apart from no power to the backlight LEDs, I have stripped it right down and tested all LEDs and they all work fine, I can see them flash briefly for a split second when powered up, the voltage to them slowly drops away after the flash so im guessing there is an issue with the power board,

            I think the model number on that is 17IPS20 and here is some pics of it

            Any help on this would be greatly appreciated,

            Thanks...
            05-10-2020, 07:11 AM
          • Hondaman
            USB problems?
            by Hondaman
            Recently I discovered my SSD died (OCZ/Toshiba 240 GB). It was in a USB enclosure, attached to the Linksys WRT-AC1200 router. Since then I removed the USB enclosure and attached it to my Win7 PC (AMD 8150 CPU, 970 chipset, 64 GB RAM). I also gathered one or two other USB enclosures to figure out what is going on.

            (I suspect that I lost quite a few MP3 and FLAC files I recently ripped from my audio CDs, I think I lost very little un-replaceable stuff.)

            I think it is IMPOSSIBLE for Win7 to have any problems with a USB enclosure as long as Win7 knows how to speak to the...
            08-12-2024, 03:26 PM
          • Loading...
          • No more items.
          Working...