Sony KDL-40EX723 5 Blinks

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • tn245
    Badcaps Veteran
    • Oct 2013
    • 530
    • UK
    #1

    Sony KDL-40EX723 5 Blinks

    Wonder if you can help me troubleshoot this one. It's doing 5 blinks of the standby light. The service manual flowchart says to look for 12V at pin 1 of CN6001 on B* board. It only very briefly spikes to 12V on switch on and then back to 0V. I have to use the peak function on my meter to catch it. I'm not sure if that counts as having 12V there or not. Should the 12V be maintained or does it get shut off once the mainboard detects an error? 5 blinks points towards t-con but what can I do to narrow down the problem?

    I'd be very grateful for any help you can give.
    Attached Files
    Tags: None
    • tn245
      Badcaps Veteran
      • Oct 2013
      • 530
      • UK
      #2
      Re: Sony KDL-40EX723 5 Blinks

      So it was the LVDS cable. Thought I'd already checked it pretty thoroughly but I gave the ends another good clean and the TV comes on now.

      It now shows a few thin horizontal lines just at the top of the screen that span the whole width. Can't seem to affect them by further cleaning or adjustment of LVDS cable. Is it worth getting a new cable or am I looking at a panel or t-con issue?
      Attached Files

        Comment

        • tn245
          Badcaps Veteran
          • Oct 2013
          • 530
          • UK
          #3
          Re: Sony KDL-40EX723 5 Blinks

          This is a panel failure right? The lines at the top? Shame. I guess this one will be sold for parts then.

            Comment

            Previous template Next

            Related Topics

            Collapse
            • AK_777
              Sony KD-65A1 Repair – 4 Red Blinks Error
              by AK_777
              Hi everyone!
              I have a Sony KD-65A1 TV with a fault – 4 red LED blinks. After disassembly and visual inspection, I found that the G76 power board and DKA board had been replaced. It is also possible that TCON was replaced, but I am not sure – there are a few marker marks that could be factory-made.

              Based on assumptions, the previous service attempted to solve the issue by replacing potentially faulty components. I decided to investigate further, found a service manual, and figured out a way to power up the power supply unit autonomously and put the OLED panel and...
              02-20-2025, 04:15 PM
            • jchon
              Sony A1e 5-blinks help
              by jchon
              Hi I'm new to trying to repair TVs, but I saw a broken OLED offered for a reasonable price and thought I'd try my hand at it.

              I found the service manual, which was critical to know where to probe.
              https://www.manualslib.com/manual/20...1e-Series.html

              With it I was able to determine that my DKA board was bad, when P_ON#1/2 gets enabled REG_12 on the DKA board collapses. I'm assuming one of the downstream regulators has a short, but I couldn't work out which rail/component and replaced the DKA board entirely.

              Unfortunately the 5-blinks...
              06-28-2023, 11:52 AM
            • Nicktronic
              Sony XBR-65X850D 2 Red Blinks
              by Nicktronic
              Hi all,

              I have the subject TV and it will work normally sometimes but suddenly go black and give the 2 red blinks blink code. When this happens, I check the power supply board voltages and all I have is the Standby 3.3V and BL_ERR 2.2V. When it's working normally, all power supply board voltages look normal and stable. I've checked the backlights with a tester and they all test good. I've also read that the 2 red blinks is a faulty power supply board, so could it be throwing up an erroneous BL_ERR?

              Any Sony experts out there that can help??...
              11-19-2023, 06:51 AM
            • dumbdd
              Sony 75X9400E TV.. 5 Red blinks
              by dumbdd
              I was using this TV for 5 years before it stopped working. I like this TV and would love to fix it myself.*

              When I press the power button, the white led comes on (sony calls the module smart core) and then it switches over to 5 red blinks. No screen, no backlight, no relay click, nothing. I have disassembled the tv and found the service manual for 75x940e online. The manual suggests a faulty power board, TCON or the panel.**

              The standby pin is at 3.3V. Fuses on the mainboard and TCON are fine. Caps on TCON also seem to be fine. When I turn on the tv the white led...
              07-01-2023, 08:54 PM
            • Nicktronic
              Sony XR-55X90J 4 blinks
              by Nicktronic
              Hey guys, got this Sony that turns on momentarily and then goes black with 4 blinks of the standby light. I can't find a service manual, but best guess was the Local Dimming board based on a similar TV saying LD_ERR or BCM_ERR. I found a replacement, but it didn't work. Before I put more money into replacement boards, Im wondering if anybody has seen this issue and what worked for them, or has the service manual for this specific TV.

              Thanks!...
              02-13-2024, 07:01 PM
            • Loading...
            • No more items.
            Working...