This board has been super helpful, so I'll say thanks ahead of time for all the knowledge you guys have. My dad has an LG 60PZ950 that's a few years old. It started having the 'pink blotchy' issue that's been reported here before. I tried reflowing the solder joints around the coils but the issue always came back.
We broke down and bought new Z-SUS and Y-SUS boards that came new through a local LG parts supplier. We replaced both boards and the problem went away. However...
Now my dad reports that the TV will lose the picture sometimes but sound will remain. Sometimes he can watch TV for 5+ hours without issue, sometimes it happens soon after turning it on. The problem resolves itself after shutting the TV off and then back on again, but of course this is annoying and probably only gets worse from here.
Any ideas on what's going on? Could replacing the y&z boards have caused this additional issue or is this something new entirely? I'm tempted to just buy a new main power board, but wanted some input first. Thanks!
We broke down and bought new Z-SUS and Y-SUS boards that came new through a local LG parts supplier. We replaced both boards and the problem went away. However...
Now my dad reports that the TV will lose the picture sometimes but sound will remain. Sometimes he can watch TV for 5+ hours without issue, sometimes it happens soon after turning it on. The problem resolves itself after shutting the TV off and then back on again, but of course this is annoying and probably only gets worse from here.
Any ideas on what's going on? Could replacing the y&z boards have caused this additional issue or is this something new entirely? I'm tempted to just buy a new main power board, but wanted some input first. Thanks!
Comment