Hello
Would anybody have the firmware for this model please
Thanks
Would anybody have the firmware for this model please
Thanks
-
-
Re: Hitachi 50HYT62U
What board is it bro ?Please Do Not PM My Page Asking For Help Badcaps Is The Place For Advise, Page Linked For Business Reasons Only. Anyone Doing So Will Be Banned Instantly !
https://www.facebook.com/Telford-Tel...7894576335359/ -
Re: Hitachi 50HYT62U
That's the problem it's definitely a vestel board but can't see any identification 17MB number but I'll check again tomorrow
ThanksComment
-
Re: Hitachi 50HYT62U
Its a 17mb95 I bet they hide the number under some plastic, remove the plastic guard over the RGB ports and you will see the board number.Please Do Not PM My Page Asking For Help Badcaps Is The Place For Advise, Page Linked For Business Reasons Only. Anyone Doing So Will Be Banned Instantly !
https://www.facebook.com/Telford-Tel...7894576335359/Comment
-
Re: Hitachi 50HYT62U
Unless I'm blind I can't find the 17mb number I'm still thinking it's the main at fault backlights work then TV just restarts in a loop
I'm also getting 73 volts going to the backlight but no voltage drop
That's why I've been searching for firmwareAttached FilesComment
-
-
Re: Hitachi 50HYT62U
Just disconnected the WIFI MODULE BOARD and now the backlight and tv stays onComment
-
Re: Hitachi 50HYT62U
Didn't want to start another thread for the same thing, could I please ask for the firmware if anyone has it? Same TV.
Board is indeed at 17MB95M sticker 10090755 23193499Comment
-
Chiedo aiuto per problema a TV Hitachi 32HE4500 che non si accende più,ho bisogno del firmware della scheda madre vestel 17MB211S codice pannello VES315UNVL-2D-N11 ?
spero che qualcuno può averlo per riprogrammare eprom. grazie
Post in English !!!
I ask for help with a problem with a Hitachi 32HE4500 TV that no longer turns on, do I need the firmware for the Vestel 17MB211S motherboard, panel code VES315UNVL-2D-N11? I hope someone can have it to reprogram eprom. Thank you
-
hi guys, can you help me to find a firmware for my hitachi 50hk6000. the tv turns on but no screen, im sure it s a firmware problem because i bought a new main board from ebay but they gave me an other version of the mainbord mine finish in s the board they gav me finish in p, and have 3 hdmi, but the tv with that board turns on but says dont signal and doesnt respond to the remote control. so someon can give me the firmaware for 50hk6000 main board 17mb130s so i can flash the eprom thansk guys02-14-2025, 02:06 PM -
Hi guys, have a nice day. I wanted to ask if anyone has the bin file for this nand MT29F4G08ABAEA. I'm attaching the model of my TV, the motherboard and the panel number. Please, if anyone can help me, thanks.
Hitachi 32HB4W56I NAND Firmware11-28-2024, 02:35 AM -
Hello to everyone ,
This is my first post here, and i would like to share with you a small story in case you can help me.
Docker Type-C Gen 2 - Model 40AS. Was given to me by a friend for free ,but with the problem that you cannot use the video output ports.
All ports work , USB , Ethernet, Type C ... but HDMI + Display Port don't work
I searched on reddit and google for problem similar to that, and a LOT of people had fixed this problem by updating the firmware. So i tried , i searched and found 1.1.13 utility and 1.1.20 utility that can help...02-10-2024, 02:07 PM -
Hi guys.
I've got a Ubiquiti US-8-150W POE switch which has issues with updating the firmware.
Turned out to be a bad EEPROM chip. It would read the firmware and work as normal, but failed to write new firmware to it.
So I took off the chip and read on EEPROM and saved it. Wrote to old chip and failed to write
Got New chip and writes good.
THE PROBLEM...
It fails to fully load the firmware, POE lights fail to work during g firmware test during load. I'm suspecting bad EEPROM Read.
Does anyone have a Good Firmware I can have?...
Comment