I mentioned this TV in another thread.
Thread: https://www.badcaps.net/forum/showthread.php?t=52781
I have replaced the inverter board, and still no backlight. And now no picture. I have done the voltage check on BOTH the Master and the new Slave board. Now, I have, like, 0VDC before and after the fuse on both boards, and, yes, I DID have both boards plugged in. It's like, first just no backlight, and now no backlight and no picture, AND there was a video input connected. It's still responsive to the remote, though. Also, when doing the voltage check, I noticed that the voltage is bouncing between 0.00VDC and 0.1x VDC on both boards. It's like the boards are trying to start up, but they are almost immediately shut down, and then they restart, doing it again. I think the Master board has failed. WHY is it doing this? WHY would replacing the Slave board cause all these problems? WHY would the TV no longer display a picture when it did earlier!? PLEASE HELP!!!
Thread: https://www.badcaps.net/forum/showthread.php?t=52781
I have replaced the inverter board, and still no backlight. And now no picture. I have done the voltage check on BOTH the Master and the new Slave board. Now, I have, like, 0VDC before and after the fuse on both boards, and, yes, I DID have both boards plugged in. It's like, first just no backlight, and now no backlight and no picture, AND there was a video input connected. It's still responsive to the remote, though. Also, when doing the voltage check, I noticed that the voltage is bouncing between 0.00VDC and 0.1x VDC on both boards. It's like the boards are trying to start up, but they are almost immediately shut down, and then they restart, doing it again. I think the Master board has failed. WHY is it doing this? WHY would replacing the Slave board cause all these problems? WHY would the TV no longer display a picture when it did earlier!? PLEASE HELP!!!

Comment