Vizio XVT3D424SV Weird Problem

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • Ltank
    Badcaps Veteran
    • Jun 2013
    • 776
    • USA
    #1

    Vizio XVT3D424SV Weird Problem

    Plug set in. Yellow Vizio turns white then shuts off. I turned set on .
    Once it had a solarized picture, indicated a had Tcon. Now I plug in set. Vizio flashes then goes off, not llighted up yellow or white but set will turn on and play just fine. Is it a intermittent Tcon or M.B.?
    I can turn set on only after the Vizio stops flashing and goes blank.
    Attached Files
    Tags: None
    • Ltank
      Badcaps Veteran
      • Jun 2013
      • 776
      • USA
      #2
      Re: Vizio XVT3D424SV Weird Problem

      The Vizio Logo flashes white 35 times then stops then turns yellow then can turned on. look like regular tv not 3D.

        Comment

        Previous template Next

        Related Topics

        Collapse
        • multimesut
          Dell 2007FPB Yellow Light Problem
          by multimesut
          Hello friends,

          A yellow light was flashing on my monitor. It was like it was constantly cutting power. When I opened it up, I saw that the big capacitor in the high voltage line was leaking. I replaced it. When I turned it on for the first time, it had the same problem again. But then, interestingly, it got better. The yellow light was on steady. But the monitor wouldn't turn on. When I examined them with a thermal camera, I saw that the Fli5961-LF reached 50 degrees Celsius and the EM636165TS next to it reached 100 degrees Celsius and was drawing high current on the motherboard....
          1 Photo
          11-13-2024, 07:00 AM
        • chaos-theory
          Nitro rx580 very weird problem, VCORE and EN
          by chaos-theory
          Hello!
          I have this very weird problem, I got this rx580 nitro saphire and the fans don't even spin but the saphire logo is lit.
          All voltage rails are present except for VCORE at the coils, then I started checking NCP81022 and it has voltage but vdd pwrgd is missing, enable EN is missing it shows 2.5ohm, everything seems fine, i tried checking the back of the card, to see where the enable pin goes, i dont have a schematic so i started touching randomly until i measured a resistor on the back and the fans started spinning, now I was amazed like what is wrong here? So I thought it's a...
          08-17-2024, 04:56 PM
        • rajbot
          No Power problem with Vizio E60-E3
          by rajbot
          Hi all:

          I have a Vizio E60-E3 I am trying to troubleshoot a no power problem with. Thanks to the help on this board and elsewhere, I was pretty sure I had narrowed it to a power board problem. The board in question is a 09-60CAP0D0-00. Image attached for reference, but not of my board (tv is put away at the moment). FWIW, no obvious looking issues with the board.

          I measured voltage at power in and on the fuse and saw 120V, so power is getting to the board.

          On the pins out to the main board, I got no voltage at all on any of the pins. I assumed this...
          03-22-2023, 08:09 AM
        • c.daniel
          Lenovo V310-15IKB weird bios problem...
          by c.daniel
          Lenovo V310-15IKB Type 80T3 laptop, i7 7th cpu with dedicated Ati video
          sn LR09493E
          MB DAOLV6MB6F0 REV. F

          The laptop was working fine, the only problem was that when I turned it on, the screen was hard to turn on, it would wait for about 30-40 seconds before an image appeared on the screen.
          Initially, I updated from windows to Intel Management Engine 11.8 Firmware, restarted, everything was fine.
          Then I updated the bios, also from windows, to the last vs, vs 46. It restarted, those lines with bios update progress appeared, restarted and that's it, since then...
          08-22-2025, 05:39 AM
        • sorrowfulfloyd
          Samsung UE32J5373AS Weird LED Problem
          by sorrowfulfloyd
          Hi all, first time seeing a LED problem this weird so I wanted to discuss with y'all before handing back this TV to my costumer.

          This TV came to my shop with no picture but sound present. So I thought ok this must be a LED problem and I shine a light with my phone's torch amd and yup I see the image. So I disassemble it and before changing the LEDs I check the motherboard voltages (this unit works with an external 16V DC brick) and I see 54 volts at the input pin of LED strip, considering this TV has 2 strips of 7 LEDs which at 3~ volts it must be equal to like 42 volts. I remove...
          12-23-2022, 07:00 AM
        • Loading...
        • No more items.
        Working...