Goodmans LD3266D tv standby mode

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • pickster
    New Member
    • Mar 2015
    • 7
    • England

    #1

    Goodmans LD3266D tv standby mode

    Hi , i need some advice pls

    I was watching this Goodmans LD3266D when it just went into standby mode , the red light was at first flashing but since unplugging the tv and trying it again the red light stays on , when i press the power button the tv comes on for like 20 seconds before going back to standby mode.

    Can this be fixed ? if so what part is broken ?
    or is it not worth repairing and buying a new one

    thx in advance for any advice
  • tom66
    EVs Rule
    • Apr 2011
    • 32560
    • UK

    #2
    Re: Goodmans LD3266D tv standby mode

    Vestel chassis probably - pretty rubbish. You can try checking PSU output voltages. The fault is most likely the PSU (it usually is on these older Vestel sets.)
    Please do not PM me with questions! Questions via PM will not be answered. Post on the forums instead!
    For service manual, schematic, boardview (board view), datasheet, cad - use our search.

    Comment

    • ReeceyBurger123
      Never Give Up !
      • May 2014
      • 7325
      • Britain

      #3
      Re: Goodmans LD3266D tv standby mode

      I think that this is a umc chassis, either eprrom or psu.
      Could you take pictures of all the boards please.
      Please Do Not PM My Page Asking For Help Badcaps Is The Place For Advise, Page Linked For Business Reasons Only. Anyone Doing So Will Be Banned Instantly !

      https://www.facebook.com/Telford-Tel...7894576335359/

      Comment

      • tom66
        EVs Rule
        • Apr 2011
        • 32560
        • UK

        #4
        Re: Goodmans LD3266D tv standby mode

        Good point. The LD3265D is Vestel. I don't think I've had the pleasure of working on a UMC like that myself.
        Please do not PM me with questions! Questions via PM will not be answered. Post on the forums instead!
        For service manual, schematic, boardview (board view), datasheet, cad - use our search.

        Comment

        • ReeceyBurger123
          Never Give Up !
          • May 2014
          • 7325
          • Britain

          #5
          Re: Goodmans LD3266D tv standby mode

          Originally posted by tom66
          Good point. The LD3265D is Vestel. I don't think I've had the pleasure of working on a UMC like that myself.
          Its a typical cheapo umc, with megmeet psu not the worst but not the best just need pics of the boards.
          Please Do Not PM My Page Asking For Help Badcaps Is The Place For Advise, Page Linked For Business Reasons Only. Anyone Doing So Will Be Banned Instantly !

          https://www.facebook.com/Telford-Tel...7894576335359/

          Comment

          • pickster
            New Member
            • Mar 2015
            • 7
            • England

            #6
            Re: Goodmans LD3266D tv standby mode

            thank you for the reply , will take off the back of the tv and get you some pictures now

            Comment

            • pickster
              New Member
              • Mar 2015
              • 7
              • England

              #7
              Re: Goodmans LD3266D tv standby mode

              here are the pictures




              Attached Files

              Comment

              • ReeceyBurger123
                Never Give Up !
                • May 2014
                • 7325
                • Britain

                #8
                Re: Goodmans LD3266D tv standby mode

                Ok well unpug the inverter and see if the tv turns on and also do you have a digital multimeter ?
                Please Do Not PM My Page Asking For Help Badcaps Is The Place For Advise, Page Linked For Business Reasons Only. Anyone Doing So Will Be Banned Instantly !

                https://www.facebook.com/Telford-Tel...7894576335359/

                Comment

                • pickster
                  New Member
                  • Mar 2015
                  • 7
                  • England

                  #9
                  Re: Goodmans LD3266D tv standby mode

                  I am not sure what i did if anything , i took out the psu to examine it for any signs it could be broken then put it back in , i tried the tv again and it came on and has stayed on for over an hour

                  Comment

                  • ReeceyBurger123
                    Never Give Up !
                    • May 2014
                    • 7325
                    • Britain

                    #10
                    Re: Goodmans LD3266D tv standby mode

                    Originally posted by pickster
                    I am not sure what i did if anything , i took out the psu to examine it for any signs it could be broken then put it back in , i tried the tv again and it came on and has stayed on for over an hour
                    Hmm maybe loose wires, give every wire a once over if the fault shows up again unplug the inverter and see if the tv powers on with out it plugged in.
                    Please Do Not PM My Page Asking For Help Badcaps Is The Place For Advise, Page Linked For Business Reasons Only. Anyone Doing So Will Be Banned Instantly !

                    https://www.facebook.com/Telford-Tel...7894576335359/

                    Comment

                    • pickster
                      New Member
                      • Mar 2015
                      • 7
                      • England

                      #11
                      Re: Goodmans LD3266D tv standby mode

                      ty for all the help and advice

                      Comment

                      • tom66
                        EVs Rule
                        • Apr 2011
                        • 32560
                        • UK

                        #12
                        Re: Goodmans LD3266D tv standby mode

                        A fault that goes away on its own will usually come back on its own... at the worst possible moment.
                        Please do not PM me with questions! Questions via PM will not be answered. Post on the forums instead!
                        For service manual, schematic, boardview (board view), datasheet, cad - use our search.

                        Comment

                        • pickster
                          New Member
                          • Mar 2015
                          • 7
                          • England

                          #13
                          Re: Goodmans LD3266D tv standby mode

                          Yes i am guessing as much , but until it does show a fault again i dont think i will be able to find the problem ?

                          i checked out the prices of a new psu and at £30 i think it will be worth replacing

                          Comment

                          • ReeceyBurger123
                            Never Give Up !
                            • May 2014
                            • 7325
                            • Britain

                            #14
                            Re: Goodmans LD3266D tv standby mode

                            Originally posted by pickster
                            Yes i am guessing as much , but until it does show a fault again i dont think i will be able to find the problem ?

                            i checked out the prices of a new psu and at £30 i think it will be worth replacing
                            Might not be the psu, you will need to test further to start pin pointing boards.
                            Please Do Not PM My Page Asking For Help Badcaps Is The Place For Advise, Page Linked For Business Reasons Only. Anyone Doing So Will Be Banned Instantly !

                            https://www.facebook.com/Telford-Tel...7894576335359/

                            Comment

                            Related Topics

                            Collapse

                            • ChristianBr01
                              LED TV Samsung The Frame 55 inch QE55LS03RAU Standby Light only
                              by ChristianBr01
                              Hello everyone,
                              I got a Samsung The Frame 55 inch TV for free from uncle cause it is not turning on anymore. I am in the second year of training as an electrician so I have knowledge already but I am far away from to be a pro.
                              The TV has Standby but ist not turning on. A Friend of mine owns a 50 inch Frame TV so I checked the One Connect Box and the One Connect Cable there. Both are good and working normally. I have opened the TV case and measured some voltages on the Board.
                              What I already found is that the 12.8V are not an the connector to the main board connector to the power...
                              04-23-2025, 01:48 AM
                            • Kaar3l
                              Samsung QLED QE65Q7FNAT only standby light
                              by Kaar3l
                              TV: Samsung QLED QE65Q7FNAT
                              PSU: BN4400940A
                              MB: BN94-12832K

                              I got the tv in spring 2024. At that time it started, then ran 60 sec and poweroff. Seemed like reboot issue. I didn't have time and room to check it in summer so I plugged it in and now the standby light is on. I press button on remote, standby light goes off and tries to start?. No picture or backlight on LCD. I thought about removing diodes like in this thread: https://www.badcaps.net/forum/troubl...sung-qled-q60r...
                              09-24-2024, 01:35 PM
                            • jasonbay13
                              Philips 37HFL5682L/F7 no standby light, incomplete service manual?
                              by jasonbay13
                              picked up a tv and when the power is plugged, the standby light flashes real quick then goes off. of 3.3, 12, 24v is all there but i couldnt find any 5v on the back-end board. ON/OFF is low, which it seems is what turns on the backlight so i removed the wire at the back-end board and put a 10k resistor to the 3.3v, which when plugged in brings on the backlight for a split second and also a blue light "LED1" on the inverter board, which goes off after a short time.
                              am i missing something to bring on the backlight or is the inverter/ccfl gone bad? would that cause the inverter board...
                              12-01-2023, 09:55 PM
                            • Nicktronic
                              Samsung UN70NU6070F Standby Light flashes twice
                              by Nicktronic
                              Hey Everyone,

                              So I've got this Samsung and the reported issue is that when powered on the backlight comes on, but no picture, no sound, it will flicker, the standby light will flash red twice and repeat the whole process...each loop lasts about 15 seconds.

                              I've googled the issue and understand it is likely a panel/driver board issue, but was hoping the "tape method" could be successful. Before I did that though, I disconnected the left LVDS cable and powered the TV on. This time I got sound, no picture and the two blink standby light stopped. Did the same...
                              03-27-2023, 07:01 PM
                            • прямо
                              Corsair HX 750W - DC Leakage at 12V Output Rail in Standby Mode
                              by прямо
                              Just received it today from a friend.
                              Auto shutdown by the supervisor IC because of an under voltage condition with 12V output rail (dropped to 10.5V)

                              The same rail also does this when the PSU is in standby mode.

                              https://ibb.co/5TBkg66

                              The leakage keeps climbing at a steady rate but slowing down when it reaches over 800mV or so. I didn't measure exactly at what value it stopped or if it's even stopped at all.

                              What could have caused that?

                              First time I have seen such behavior.

                              3.3V and 5V rails don't have the same...
                              02-19-2024, 09:52 PM
                            • Loading...
                            • No more items.
                            Working...