Smart tv Zephir no imagine

[labello]

Hi guys i have this kind of smart tv , audio is present , backlight is present too but no picture. I measured voltage on the pannel and seems OK.. but I'm not sure about that, I'll post the measurements. Thanks for the reply
VGH 36.14
VCC 12.24
VGL -8.890
VAA 13.30
(VDD 33) 3.3
VGL_TFT 5.977
VSSI -5.978

VGH. 36.09
VCC. 12.25
VGL. -8.880
VAA. 15.25
(VDD 33) 3.323
VGL_ TFT. 5.973
VSSI - 5.970

Here the difference after the (mod) thanks

[lotas]

You did everything correctly, the panel went into test mode, if there are no defects in the image, then the problem is either in the cable itself or in the motherboard (firmware, processor, dc/dc converters, ...).

[Diah]

take out the heatsink from the SoC and show here good photo of it and around

[lotas]

The radiator here isn't easy to remove; it's held in place by four pins soldered to the back of the motherboard. Without experience, you could ruin the motherboard.

[Diah]

Without experience, you could ruin the motherboard.

first think i asked him to check LVDS signal ......MB already ruined

[lotas]

If there were signals on LVDS, there would be an image too.