Sony Bravia Tv 32 inch KLV 32V400A

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • slay283
    New Member
    • Aug 2014
    • 3
    • Brunei

    #1

    Sony Bravia Tv 32 inch KLV 32V400A

    Hi, i have a this tv broken a few years ago and i am trying to fix it if its possible and easy to do it.
    When i turn it on it blinks eight times and i already plug off all the audio that plug in. So may i know what the problem is and how to fix it. Thank you.
  • meziey80
    New Member
    • Jul 2014
    • 2
    • malaysia

    #2
    Re: Sony Bravia Tv 32 inch KLV 32V400A

    i do have same problem, same model, its blink 8 times, still searching forum for solution.
    problem coz by audio, maybe hdmi ic

    Comment

    • anmol
      Senior Member
      • Mar 2012
      • 73
      • India

      #3
      Re: Sony Bravia Tv 32 inch KLV 32V400A

      Check this?

      Regards
      Attached Files

      Comment

      Related Topics

      Collapse

      • PopsCaps
        Sony Bravia KDL-40V2500 that will not power on
        by PopsCaps
        I have a Sony Bravia KDL-40V2500 that will not power on. The indicator flashes red 3 times.
        I do not hear any sound and I cannot see any backlight.
        I have tried disconnecting every cable on each board one at a time to see if anything changes.
        The only change is when I disconnect AC-DET cable on the Power Supply board or on the other end if I unplug the CN7009 connection on the B-Board and try to power on the TV the indicator will stay on solid green until I power off.
        My friend ordered another used power supply board but it is also doing the red indicator flash 3 times...
        03-25-2025, 11:23 AM
      • matwan
        Sony XR-55X90J 5 blinks
        by matwan
        Hello,

        I have problem with SONY 55X90J. After several check status is as below;
        1. Running power board as stand alone:

        TCON_12V =~ 12.6V
        EVDD V On Max 24V= 19V.

        2.
        Running power board with TCON as stand alone:

        Effect as below, attched.

        3. When bottom LVDS cable is disconnected no blinks, but of course no TCON 12V and EVDD.
        "I'm almost sure it's a defective panel, but maybe someone has encountered a similar issue on their screen.

        Best regards....
        09-28-2025, 04:26 AM
      • GoodCapDude
        Sony XBR-75X940E intermittent 6 blinks error code
        by GoodCapDude
        Hi everyone. First post on Badcaps!

        I am trying to fix a Sony 940E from 2017 that either starts normally (and works perfectly until turned off) or goes straight to the 6 blinks error code without showing anything on the screen. It is frustrating to know that it can still work perfectly but is barely usable because of the difficulty starting it up. I am willing to try to short the BL_ERR but I would like to avoid that if possible. Does anyone have a view on this? Thanks a lot....
        09-20-2025, 06:07 AM
      • AK_777
        Sony KD-65A1 Repair – 4 Red Blinks Error
        by AK_777
        Hi everyone!
        I have a Sony KD-65A1 TV with a fault – 4 red LED blinks. After disassembly and visual inspection, I found that the G76 power board and DKA board had been replaced. It is also possible that TCON was replaced, but I am not sure – there are a few marker marks that could be factory-made.

        Based on assumptions, the previous service attempted to solve the issue by replacing potentially faulty components. I decided to investigate further, found a service manual, and figured out a way to power up the power supply unit autonomously and put the OLED panel and...
        02-20-2025, 04:15 PM
      • jchon
        Sony A1e 5-blinks help
        by jchon
        Hi I'm new to trying to repair TVs, but I saw a broken OLED offered for a reasonable price and thought I'd try my hand at it.

        I found the service manual, which was critical to know where to probe.
        https://www.manualslib.com/manual/20...1e-Series.html

        With it I was able to determine that my DKA board was bad, when P_ON#1/2 gets enabled REG_12 on the DKA board collapses. I'm assuming one of the downstream regulators has a short, but I couldn't work out which rail/component and replaced the DKA board entirely.

        Unfortunately the 5-blinks...
        06-28-2023, 11:52 AM
      • Loading...
      • No more items.
      Working...