RTRU6528-C-CA

[x2006nzl]

Hello everyone,
I have a RTRU6528-C-CA the leds went i took it apart and ordered the same nu.bers they fit and the holes are right but the connectors a bit different can I cut the connector and solder the positive to the positive and negative to the negative on the led strip for it to work thanks

[Diah]

just be caution on the LEDs self if they are installed on the strips in opposite way too, so check and compare with yours old one, if they are correct installed + - as the old then ok

[x2006nzl]

Thanks for the reply so I can just cut the connectors off and solder the wires to the + and - on the led strips for the tv thanks

[x2006nzl]

And is there something i can put over it once it's soldered thanks

[lotas]

Solder to these pads, observing the polarity and there is no need to add anything.

[x2006nzl]

Also with this tv when I took it apart the reflective paper was taped/glued so most of it ripped so I took off all the pieces and bought a reflective paper, can I overlap the pieces as the roll isn't wide enough so I have to piece it together and should I use double sided tape or tape and will it effect the screen? Thanks