Ok Diah, I trust you, have seen lots of problems with these in the past, was going by Lotus's comment about them a while back when he said they cause lots of problems and were not important.
-
-
Thanks Diah and all others.
I'll try to put them back when I have a chance. Currently I'm running stress test over night see if it stays. I might damaged one 6514p and need to test it out. I'm afraid I will ruin the scan/panel board when I use the heat gun to put them back...
Picture looks flawless in both SDR and HDR mode now.
Another concerns is how long it will last as it starts to fail. These new Samsung TVs really disappointing me on the reliability.. (I have Q8\Frame\Sero)
Attached FilesComment
-
-
Yep, sammys are NOT what they use to be.Comment
-
So taping did the trick for you? Sometimes you can get rid of all the lines by trying blocking different lines, was a guy who spent a LOT of time trying a while back, can't recall if he got rid of all of them or not, the search on this site isn't as good as it use to be so I didn't search for it.Last edited by nomoresonys; 07-14-2024, 09:16 AM.Comment
-
I tap out the out-most few pins on the ribbon cable to the last scan/panel board. Maybe it only needs 2 pins but I didn't bother to test each of them.
I tried tap out the main ribbon cable without luck as I wasn't aware the right most driver board is over heated on few resistors until Iotas pointed out the dark resistor.
It ends up with a simple tap fix at least for now..
Many thanks to everyone whom helped and I learnt a lot hop these step will help future readers.
I'll keep the thread updated if anything else happens later.
Attached FilesComment
-
-
This specification for the Samsung 13.3IN CHROMEBOOK 2 8GB/128GB FHD QLED MERCURY GRAY I3-10110U Chromebook can be useful for upgrading or repairing a laptop that is not working. As a community we are working through our specifications to add valuable data like the 13.3IN CHROMEBOOK 2 8GB/128GB FHD QLED MERCURY GRAY I3-10110U boardview and 13.3IN CHROMEBOOK 2 8GB/128GB FHD QLED MERCURY GRAY I3-10110U schematic. Our users have donated over 1 million documents which are being added to the site. This page will be updated soon with additional information. Alternatively you can request additional help...09-07-2024, 12:10 AM
-
This specification for the Samsung Galaxy Book 2 Notebook can be useful for upgrading or repairing a laptop that is not working. As a community we are working through our specifications to add valuable data like the Galaxy Book 2 boardview and Galaxy Book 2 schematic. Our users have donated over 1 million documents which are being added to the site. This page will be updated soon with additional information. Alternatively you can request additional help from our users directly on the relevant badcaps forum. Please note that we offer no warranties that any specification, datasheet, or download...09-07-2024, 05:50 AM
-
TV: Samsung QLED QE65Q7FNAT
PSU: BN4400940A
MB: BN94-12832K
I got the tv in spring 2024. At that time it started, then ran 60 sec and poweroff. Seemed like reboot issue. I didn't have time and room to check it in summer so I plugged it in and now the standby light is on. I press button on remote, standby light goes off and tries to start?. No picture or backlight on LCD. I thought about removing diodes like in this thread: https://www.badcaps.net/forum/troubl...sung-qled-q60r... -
Hello everybody,
my TV has a problem. It keeps turning on and off. The speakers are still working, and I hooked up the TV to my PC, and it recognizes it as a Samsung device. I am able to get a stable backlight when I disconnect the cable(I believe it is called the LVDS cable) that connects the left lower board (which is connected to the "main board") and the right lower board. I have tried a taping method I saw on YouTube, where the CLK cables are taped off. In fact, I proceeded to figure out which pin I have to tape off in order to get a stable backlight. It doesn't matter... -
Samsung QLED QN50Q — purchased 2022 started experiencing a delay in the picture coming on in the morning less than 2 years later. Did not know the term boot loop at that time. As the loop delay ran into a few minutes did all the recommended troubleshooting, soft and hard reset, changing cables and outlet locations, no help. As the delay increased contacted Samsung tech group and allow them remote access the tv. Tech was moving too fast to see exactly what he was doing but this ultimately it was also no help. Lived with the delay until it stretched out over 6 hours. Pulled of off the back cover...
Comment