Re: Sharp LC-40LE810UN question
I think we have to hold on a bit with all these ideas.
We get carried away and we are not covering the basics.
Right now I'm using the original board and it seems that is working "OK" up to a point.
I'm saying it's OK up to that point where are the two capacitors(brown and black), there I have the 5.5V respectively the 13.2V.
Another problem is that I'm seeing is that the 13.2V it's not reaching the mainboard. Only the 5.02V goes through.
If I measure the two power double diodes, at the middle pins I should measure 5V respectively 13.2V, no? The 13.2V it's not there.
No 400V either, only the 168V.
I think we have to hold on a bit with all these ideas.
We get carried away and we are not covering the basics.
Right now I'm using the original board and it seems that is working "OK" up to a point.
I'm saying it's OK up to that point where are the two capacitors(brown and black), there I have the 5.5V respectively the 13.2V.
Another problem is that I'm seeing is that the 13.2V it's not reaching the mainboard. Only the 5.02V goes through.
If I measure the two power double diodes, at the middle pins I should measure 5V respectively 13.2V, no? The 13.2V it's not there.
No 400V either, only the 168V.
Comment