looking for samsung upper and lower y-buffers. one section out on top and all out on bottom on mine
-
I just acquired this portable aircon, history unknown. Its behaviour is quite strange:
- When turned on and placed into cooling mode, the upper fan (cold air out) just spins slowly. The compressor and lower fan do not run.
- If the device is then placed into heating mode and then back into cooling mode, the lower fan and compressor kick in and start cooling, but the upper fan still only spins slowly.
- If the device is placed into fan-only mode, the upper fan does not respond to low/medium/high speed toggles - just keeps running slowly.
- Display and buttons all behave normally aside from the
-
Hi
i have a a2179 which is locked. On the other hand I have an unlock t2chip(just the upper layer of ic)I wanna know if I can just change the upper layer of the t2 chip.
any way does anyone know what each layer do?08-03-2024, 01:46 AM -
Just wanted to get some feedback,
whats peoples' success rate with cof bonding repairs..... -
Hi All,
I'm chasing a circuit schematic for an Asus CUV4x Motherboard.
I purchased the board in 'unknown' condition and it doesn't exhibit any signs of life when testing with known good parts.
The board does not power on - No LED illuminated when ATX power connected. When bridging the PS_ON to Ground at the ATX connector the board will power up however seems to fail early chipset initialization at post code C0
Any help greatly appreciated as I'd love to get this cool 'retro' board back to life to live another 25 years!
Thanks
-
My wife is asking me about getting one because our electric bill was that it has ever been even more than last year at this time nothing has really changed since last year last month unless the electric company has done some fuel adjustment charges I have not done any investigation into yet but I might have to but there was a time back a few years ago that I use to set the temperature warm during the day when we were not home but when we got wooden floors in our house and you have to keep the humidity down to keep it from warping I just set to a temperature to 75*F to keep the humidity down but...