Samsung LN32C530 will not turn on. Standby light just blinks

Collapse
X
Collapse
 
  • Page of 3
  • Time
  • Show
Clear All
new posts
Previous 1 2 3 template Next
  • Johnsonn
    New Member
    • May 2022
    • 5
    • Canada
    #41
    Re: Samsung LN32C530 will not turn on. Standby light just blinks

    Originally posted by dskall
    Do you get backlights when you push power? If no do you get an image on screen if you push menu and check with flashlight? If no what are you voltages on connector CN802 to main when in standby and when power button pushed?
    No backlight after I press power.
    I will have to check but I dont think there is a picture with no backlight.
    I will check the voltages and report back.

      Comment

      Previous 1 2 3 template Next

      Related Topics

      Collapse
      • Jackching
        Samsung UN46EH5000F wont turn on. Blinks red standby light continuously
        by Jackching
        I know for sure it has a bad cap and one cold solder joint. Just wondering before i order the Caps if anyone has any experience with this model? Just making sure there isnt a common component that goes bad besides the caps....
        04-15-2024, 05:14 PM
      • ChristianBr01
        LED TV Samsung The Frame 55 inch QE55LS03RAU Standby Light only
        by ChristianBr01
        Hello everyone,
        I got a Samsung The Frame 55 inch TV for free from uncle cause it is not turning on anymore. I am in the second year of training as an electrician so I have knowledge already but I am far away from to be a pro.
        The TV has Standby but ist not turning on. A Friend of mine owns a 50 inch Frame TV so I checked the One Connect Box and the One Connect Cable there. Both are good and working normally. I have opened the TV case and measured some voltages on the Board.
        What I already found is that the 12.8V are not an the connector to the main board connector to the power...
        04-23-2025, 01:48 AM
      • Kaar3l
        Samsung QLED QE65Q7FNAT only standby light
        by Kaar3l
        TV: Samsung QLED QE65Q7FNAT
        PSU: BN4400940A
        MB: BN94-12832K

        I got the tv in spring 2024. At that time it started, then ran 60 sec and poweroff. Seemed like reboot issue. I didn't have time and room to check it in summer so I plugged it in and now the standby light is on. I press button on remote, standby light goes off and tries to start?. No picture or backlight on LCD. I thought about removing diodes like in this thread: https://www.badcaps.net/forum/troubl...sung-qled-q60r...
        09-24-2024, 01:35 PM
      • Nicktronic
        Samsung UN70NU6070F Standby Light flashes twice
        by Nicktronic
        Hey Everyone,

        So I've got this Samsung and the reported issue is that when powered on the backlight comes on, but no picture, no sound, it will flicker, the standby light will flash red twice and repeat the whole process...each loop lasts about 15 seconds.

        I've googled the issue and understand it is likely a panel/driver board issue, but was hoping the "tape method" could be successful. Before I did that though, I disconnected the left LVDS cable and powered the TV on. This time I got sound, no picture and the two blink standby light stopped. Did the same...
        03-27-2023, 07:01 PM
      • SJX1290
        No Standby Light on Samsung SAMSUNG UE65NU7022
        by SJX1290
        I have Samsung UN65MU6300FXZA with Mainboard BN41-02662A, dead , No Standby Light. I suspect result of main power jumping. Checked all voltages on main board ok,..
        My main suspect is bad flash memory, ...
        Any suggestions or can someone please​ check dump file, in the attachment
        Thank you...
        09-07-2024, 01:35 AM
      • Loading...
      • No more items.
      Working...