Dude is bringing over a Hitachi P50S601 (plasma 1080)

[freakaftr8]

Re: Dude is bringing over a Hitachi P50S601 (plasma 1080)

Yea sorry thats it.

[georugby]

Re: Dude is bringing over a Hitachi P50S601 (plasma 1080)

Cant read the location but on the bottom it right above the stamping FCVV4 on the top same ic. Its the 3 pin one with one pin on the opposite side. Check in ohms Range center pin to each end for shorts.

putting my red pointer on the center pin, and putting the black on each end gave me in ohms 620-817 for the upper ysus and 621-795 for the lower one.

doesn't seem to have any problem there.

My problem on my upper buffer board is that I ran my multimeter on each little ceramic capacitor for the ic chips and even if two ic's shows blown-up evidence, two other lectures gives me that I have two more blown ic....so 4 blown ic chips, i'll re-evaluate if i'm better off with a use board instead....

[Shadow Dragon]

Re: Dude is bringing over a Hitachi P50S601 (plasma 1080)

Just trying to see if you ever had a final solution to fixing this problem. I have the same thing exactly going on.

[electrodude71]

Re: Dude is bringing over a Hitachi P50S601 (plasma 1080)

hi guys, if anybody needs any parts for one of these i have one with a bad lower buffer, but other than the lower half of the video not working everything else seems to work fine. thaks

[CodyJv]

Re: Dude is bringing over a Hitachi P50S601 (plasma 1080)

http://www.youtube.com/watch?v=2HEjF8IHQDw

Bad caps and y-sus board? I picked it up for free... sorry if reviving old topic is against rules. Would be nice to repair. Looked on ebay and the boards are $84ish and just curious if it would be beneficial to try at those costs. I found another guy with a similar issue... but his stays the same, mine flashes to an almost perfect picture.